[PATCH 1/1] dt-bindings: pwm: rockchip: Add description for rk3588

[Johan Jonker]

On 9/13/22 16:16, Sebastian Reichel wrote:
> Hi,
> 
> On Tue, Sep 13, 2022 at 11:12:02AM +0200, Uwe Kleine-König wrote:
>> Hello Rob,
>>
>> On Thu, Sep 01, 2022 at 02:14:55PM -0500, Rob Herring wrote:
>>> On Thu, 01 Sep 2022 15:55:23 +0200, Sebastian Reichel wrote:
>>>> Add "rockchip,rk3588-pwm" compatible string for PWM nodes found
>>>> on a rk3588 platform.
>>>>
>>>> Signed-off-by: Sebastian Reichel <sebastian.reichel at collabora.com>
>>>> ---
>>>> No driver changes required.
>>>> ---
>>>>  Documentation/devicetree/bindings/pwm/pwm-rockchip.yaml | 1 +
>>>>  1 file changed, 1 insertion(+)
>>>>
>>>
>>> Running 'make dtbs_check' with the schema in this patch gives the
>>> following warnings. Consider if they are expected or the schema is
>>> incorrect. These may not be new warnings.
>>>
>>> Note that it is not yet a requirement to have 0 warnings for dtbs_check.
>>> This will change in the future.
>>
>> Is this a list of *new* warnings, or is the report (somewhat) orthogonal
>> to the actual change and you just used the opportunity that someone
>> touched the pwm-rockchip binding to point out that there is some cleanup
>> to do?
>>
>>> Full log is available here: https://patchwork.ozlabs.org/patch/
>>
>> Hm, that gives me a 404.
> 

> This is an existing problem with the rv1108 binding.
> The rk3588 does not have pwm interrupts.

Hi,

Could you recheck?

>From Rockchip RK3588 Datasheet V0.1-20210727.pdf:

PWM
Support 16 on-chip PWMs(PWM0~PWM15) with interrupt-based operation
Programmable pre-scaled operation to bus clock and then further scaled
Embedded 32-bit timer/counter facility
Support capture mode
Support continuous mode or one-shot mode
Provides reference mode and output various duty-cycle waveform
Optimized for IR application for PWM3, PWM7, PWM11, PWM15

===

ARM: dts: rk3288: add the interrupts property for PWM 
https://github.com/rockchip-linux/kernel/commit/16b7b284618d1652e694f6286f575ce82f5f03e5

Comment:
At the moment, we can find the remotectl pwm is needed on box.
We can add the property for all PWMs. AFAIK, the pwm driver don't use it
but the drivers/input/remotectl/rockchip_pwm_remotectl.c

===

>From Rockchip RK3568 TRM Part1 V1.1-20210301.pdf

8-bit repeat counter for one-shot operation. One-shot operation will produce N + 1
periods of the waveform, where N is the repeat counter value, and generates a
single interrupt at the end of operation

Continuous mode generates the waveform continuously, and does not generates
any interrupts

> 
> -- Sebastian
> 
> 
> _______________________________________________
> Linux-rockchip mailing list
> Linux-rockchip at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-rockchip