[PATCH v2 2/2] arm64: dts: rockchip: Add Bananapi R2 Pro

[Sascha Hauer]

On Sun, Jan 23, 2022 at 02:51:16PM +0100, Frank Wunderlich wrote:
> From: Frank Wunderlich <frank-w at public-files.de>
> 
> This patch adds Devicetree for Bananapi R2 Pro based on RK3568.
> Add uart/sd/emmc/i2c/rk809/tsadc nodes for basic function.
> Gmac0 is directly connected to wan-port so usable without additional
> driver.
> On gmac1 there is a switch (rtl8367rb) connected which have not yet a
> driver in mainline.
> 
> Patch also prepares nodes for GPIO header.
> 
> Co-developed-by: Peter Geis <pgwipeout at gmail.com>
> Signed-off-by: Peter Geis <pgwipeout at gmail.com>
> Signed-off-by: Frank Wunderlich <frank-w at public-files.de>
> ---
> +&gmac0 {
> +	assigned-clocks = <&cru SCLK_GMAC0_RX_TX>, <&cru SCLK_GMAC0>;
> +	assigned-clock-parents = <&cru SCLK_GMAC0_RGMII_SPEED>, <&cru CLK_MAC0_2TOP>;
> +	clock_in_out = "input";
> +	phy-handle = <&rgmii_phy0>;
> +	phy-mode = "rgmii";
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&gmac0_miim
> +		     &gmac0_tx_bus2
> +		     &gmac0_rx_bus2
> +		     &gmac0_rgmii_clk
> +		     &gmac0_rgmii_bus>;
> +
> +	snps,reset-gpio = <&gpio3 RK_PB7 GPIO_ACTIVE_LOW>;
> +	snps,reset-active-low;
> +	/* Reset time is 20ms, 100ms for rtl8211f */

Is this really a rtl8211f? I don't know and it could indeed be a
rtl8211f, I'm just asking because the comment is copy pasted from
the Quartz64 board.

> +	snps,reset-delays-us = <0 20000 100000>;
> +
> +&mdio0 {
> +	rgmii_phy0: ethernet-phy at 0 {
> +		compatible = "ethernet-phy-ieee802.3-c22";
> +		reg = <0x0>;
> +	};

0 is the broadcast address. I'm not sure if it's a good idea to use it.
There should be another address the phy listens on.

Sascha

-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |