[PATCH 2/5] riscv: dts: spacemit: enable the i2c2 adapter on K3 Pico-ITX board

[Aurelien Jarno]

Define I2C2 pinctrl properties, and enable it on the K3 Pico-ITX board.
It will be used by the 24c02 eeprom.

Signed-off-by: Aurelien Jarno <aurelien at aurel32.net>
---
 arch/riscv/boot/dts/spacemit/k3-pico-itx.dts |  6 ++++++
 arch/riscv/boot/dts/spacemit/k3-pinctrl.dtsi | 11 +++++++++++
 2 files changed, 17 insertions(+)

diff --git a/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts b/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts
index 509cebc0c9568..5fe9041ec5702 100644
--- a/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts
+++ b/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts
@@ -43,6 +43,12 @@ reg_aux_vcc5v: regulator-aux-vcc5v {
 	};
 };
 
+&i2c2 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&i2c2_1_cfg>;
+	status = "okay";
+};
+
 &i2c8 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&i2c8_cfg>;
diff --git a/arch/riscv/boot/dts/spacemit/k3-pinctrl.dtsi b/arch/riscv/boot/dts/spacemit/k3-pinctrl.dtsi
index 3ee1471f37985..2017aa14fb424 100644
--- a/arch/riscv/boot/dts/spacemit/k3-pinctrl.dtsi
+++ b/arch/riscv/boot/dts/spacemit/k3-pinctrl.dtsi
@@ -78,6 +78,17 @@ gmac1-phy-0-pins {
 		};
 	};
 
+	/omit-if-no-ref/
+	i2c2_1_cfg: i2c2-1-cfg {
+		i2c2-0-pins {
+			pinmux = <K3_PADCONF(46, 5)>,	/* i2c2 scl */
+				 <K3_PADCONF(47, 5)>;	/* i2c2 sda */
+
+			bias-pull-up= <0>;
+			drive-strength = <25>;
+		};
+	};
+
 	/omit-if-no-ref/
 	i2c8_cfg: i2c8-cfg {
 		i2c8-pins {
-- 
2.53.0