[PATCH v2 2/2] riscv: dts: spacemit: Fix phy id check for the phy on com260 board

[Inochi Amaoto]

Current phy framework can not re-initialize the phy correctly, as it will
assert the phy reset GPIO so the phy id can not be read. Setting the
phy id of board com260 manually so the phy id dectection can be skipped.

Fixes: cfe5c91cb73c ("riscv: dts: spacemit: k3: Initial support for CoM260-IFX board")
Signed-off-by: Inochi Amaoto <inochiama at gmail.com>
---
 arch/riscv/boot/dts/spacemit/k3-com260.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/riscv/boot/dts/spacemit/k3-com260.dtsi b/arch/riscv/boot/dts/spacemit/k3-com260.dtsi
index b704b537385c..2a07cd8f2a56 100644
--- a/arch/riscv/boot/dts/spacemit/k3-com260.dtsi
+++ b/arch/riscv/boot/dts/spacemit/k3-com260.dtsi
@@ -174,7 +174,7 @@ &eth1 {
 
 	mdio {
 		phy1: phy at 1 {
-			compatible = "ethernet-phy-ieee802.3-c22";
+			compatible = "ethernet-phy-id001c.c916";
 			reg = <1>;
 			reset-gpios = <&gpio 1 5 GPIO_ACTIVE_LOW>;
 			reset-assert-us = <10000>;
-- 
2.55.0