[PATCH v2 1/2] riscv: dts: spacemit: Fix phy id check for the phy on pico-itx board

[Inochi Amaoto]

Current phy framework can not re-initialize the phy correctly, as it will
assert the phy reset GPIO so the phy id can not be read. Setting the
phy id of board pico-itx manually so the phy id detection can be skipped.

Fixes: 74657a376960 ("riscv: dts: spacemit: Add ethernet device for K3")
Reported-by: E Shattow <e at freeshell.de>
Reported-by: Inochi Amaoto <inochiama at gmail.com>
Closes: https://lore.kernel.org/netdev/20260712045233.800748-1-inochiama@gmail.com
Signed-off-by: Inochi Amaoto <inochiama at gmail.com>
Tested-by: E Shattow <e at freeshell.de>
---
 arch/riscv/boot/dts/spacemit/k3-pico-itx.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts b/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts
index b2a7d2d0d3a8..d78416f3118e 100644
--- a/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts
+++ b/arch/riscv/boot/dts/spacemit/k3-pico-itx.dts
@@ -196,7 +196,7 @@ &eth0 {
 
 	mdio {
 		phy0: phy at 1 {
-			compatible = "ethernet-phy-ieee802.3-c22";
+			compatible = "ethernet-phy-id001c.c916";
 			reg = <1>;
 			reset-gpios = <&gpio 0 15 GPIO_ACTIVE_LOW>;
 			reset-assert-us = <10000>;
-- 
2.55.0