[PATCH] thermal: spacemit: k1: disable hardware on driver remove

[Pei Xiao]

在 2026/7/13 16:40, Troy Mitchell 写道:
> On Mon Jul 13, 2026 at 1:32 AM PDT, Pei Xiao wrote:
>> The driver uses devm_request_threaded_irq() but never disables the
>> hardware interrupt enable, sensor enable, or sensor power bits when
>> the driver is unbound.
>>
>> Add a devm action that clears K1_TSENSOR_INT_EN_REG,
>> K1_TSENSOR_EN_ALL, and K1_TSENSOR_PCTRL_ENABLE on remove, mirroring
>> what k1_tsensor_init() sets up.
>>
>> Signed-off-by: Pei Xiao <xiaopei01 at kylinos.cn>
>> ---
>>  drivers/thermal/spacemit/k1_tsensor.c | 27 +++++++++++++++++++++++++++
>>  1 file changed, 27 insertions(+)
>>
>> diff --git a/drivers/thermal/spacemit/k1_tsensor.c b/drivers/thermal/spacemit/k1_tsensor.c
>> index 79222d233129..cf79dc7d403f 100644
>> --- a/drivers/thermal/spacemit/k1_tsensor.c
>> +++ b/drivers/thermal/spacemit/k1_tsensor.c
>> @@ -199,6 +199,29 @@ static irqreturn_t k1_tsensor_irq_thread(int irq, void *data)
>>  	return IRQ_HANDLED;
>>  }
>>  
>> +static void k1_tsensor_shutdown(struct k1_tsensor *ts)
>> +{
>> +	u32 val;
>> +
>> +	/* Disable all interrupts */
>> +	writel(0xffffffff, ts->base + K1_TSENSOR_INT_EN_REG);
>> +
>> +	/* Disable all sensor */
>> +	val = readl(ts->base + K1_TSENSOR_EN_REG);
>> +	val &= ~K1_TSENSOR_EN_ALL;
>> +	writel(val, ts->base + K1_TSENSOR_EN_REG);
>> +
>> +	/* Power down the sensor module */
>> +	val = readl(ts->base + K1_TSENSOR_PCTRL_REG);
>> +	val &= ~K1_TSENSOR_PCTRL_ENABLE;
> Why is only the ENABLE bit cleared here?
> At init time the driver also sets:
>     val |= K1_TSENSOR_PCTRL_RAW_SEL |
>     K1_TSENSOR_PCTRL_TEMP_MODE |
>     K1_TSENSOR_PCTRL_HW_AUTO_MODE |
>     K1_TSENSOR_PCTRL_ENABLE;
>
> Should the other bits be cleared in shutdown as well, or is clearing ENABLE
> alone?
Hi Troy,
 Maybe Wu(author) have someting to say about these regs.
 Thanks.

Pei.


>                             - Troy