[PATCH] thermal: spacemit: k1: disable hardware on driver remove

[Troy Mitchell]

On Mon Jul 13, 2026 at 1:32 AM PDT, Pei Xiao wrote:
> The driver uses devm_request_threaded_irq() but never disables the
> hardware interrupt enable, sensor enable, or sensor power bits when
> the driver is unbound.
>
> Add a devm action that clears K1_TSENSOR_INT_EN_REG,
> K1_TSENSOR_EN_ALL, and K1_TSENSOR_PCTRL_ENABLE on remove, mirroring
> what k1_tsensor_init() sets up.
>
> Signed-off-by: Pei Xiao <xiaopei01 at kylinos.cn>
> ---
>  drivers/thermal/spacemit/k1_tsensor.c | 27 +++++++++++++++++++++++++++
>  1 file changed, 27 insertions(+)
>
> diff --git a/drivers/thermal/spacemit/k1_tsensor.c b/drivers/thermal/spacemit/k1_tsensor.c
> index 79222d233129..cf79dc7d403f 100644
> --- a/drivers/thermal/spacemit/k1_tsensor.c
> +++ b/drivers/thermal/spacemit/k1_tsensor.c
> @@ -199,6 +199,29 @@ static irqreturn_t k1_tsensor_irq_thread(int irq, void *data)
>  	return IRQ_HANDLED;
>  }
>  
> +static void k1_tsensor_shutdown(struct k1_tsensor *ts)
> +{
> +	u32 val;
> +
> +	/* Disable all interrupts */
> +	writel(0xffffffff, ts->base + K1_TSENSOR_INT_EN_REG);
> +
> +	/* Disable all sensor */
> +	val = readl(ts->base + K1_TSENSOR_EN_REG);
> +	val &= ~K1_TSENSOR_EN_ALL;
> +	writel(val, ts->base + K1_TSENSOR_EN_REG);
> +
> +	/* Power down the sensor module */
> +	val = readl(ts->base + K1_TSENSOR_PCTRL_REG);
> +	val &= ~K1_TSENSOR_PCTRL_ENABLE;
Why is only the ENABLE bit cleared here?
At init time the driver also sets:
    val |= K1_TSENSOR_PCTRL_RAW_SEL |
    K1_TSENSOR_PCTRL_TEMP_MODE |
    K1_TSENSOR_PCTRL_HW_AUTO_MODE |
    K1_TSENSOR_PCTRL_ENABLE;

Should the other bits be cleared in shutdown as well, or is clearing ENABLE
alone?

                            - Troy