[PATCH v10 3/3] iio: dac: Add AD5529R DAC driver support

[Andy Shevchenko]

On Thu, Aug 27, 2026 at 10:30:19AM +0200, Joshua Crofts wrote:
> On Thu, 27 Aug 2026 09:34:48 +0200
> Janani Sunil <janani.sunil at analog.com> wrote:

...

> > +#include <linux/array_size.h>
> > +#include <linux/bits.h>
> > +#include <linux/delay.h>
> > +#include <linux/dev_printk.h>
> > +#include <linux/err.h>
> > +#include <linux/errno.h>
> > +#include <linux/iio/iio.h>
> 
> IIO specific headers should go after the generic <linux/*> headers,
> it's just convention.
> 
> > +#include <linux/module.h>
> > +#include <linux/property.h>
> > +#include <linux/regmap.h>
> > +#include <linux/regulator/consumer.h>
> > +#include <linux/reset.h>
> > +#include <linux/spi/spi.h>
> > +#include <linux/types.h>
> > +#include <linux/units.h>

When it's a single header we don't strict this too much.

...

> > +static int ad5529r_write_raw(struct iio_dev *indio_dev,
> > +			     struct iio_chan_spec const *chan,
> > +			     int val, int val2, long mask)
> > +{
> > +	struct ad5529r_state *st = iio_priv(indio_dev);
> > +	unsigned int reg_addr;
> > +
> > +	switch (mask) {
> > +	case IIO_CHAN_INFO_RAW:
> > +		if (val < 0 || val > GENMASK(st->model_data->resolution - 1, 0))
> 
> There is a function for this - in_range(), in linux/minmax.h.

This is a trade-off and sometimes open-coded variants are okay.
I'm fine with either.

> > +			return -EINVAL;
> > +
> > +		reg_addr = AD5529R_REG_DAC_INPUT_A(chan->channel);
> > +
> > +		return regmap_write(st->regmap_16bit, reg_addr, val);
> > +	default:
> > +		return -EINVAL;
> > +	}
> > +}

-- 
With Best Regards,
Andy Shevchenko