[PATCH net-next v12 4/5] riscv: dts: spacemit: Add Ethernet support for BPI-F3

[Vivian Wang]

On 9/14/25 12:23, Vivian Wang wrote:
> Banana Pi BPI-F3 uses an RGMII PHY for each port and uses GPIO for PHY
> reset.
>
> Tested-by: Hendrik Hamerlinck <hendrik.hamerlinck at hammernet.be>
> Signed-off-by: Vivian Wang <wangruikang at iscas.ac.cn>
> Reviewed-by: Yixun Lan <dlan at gentoo.org>
> Reviewed-by: Andrew Lunn <andrew at lunn.ch>
> ---
>  arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts | 48 +++++++++++++++++++++++++
>  1 file changed, 48 insertions(+)
>
> diff --git a/arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts b/arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts
> index fe22c747c5012fe56d42ac8a7efdbbdb694f31b6..33e223cefd4bd3a12fae176ac6cddd8276cb53dc 100644
> --- a/arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts
> +++ b/arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts
> @@ -11,6 +11,8 @@ / {
>  	compatible = "bananapi,bpi-f3", "spacemit,k1";
>  
>  	aliases {
> +		ethernet0 = &eth0;
> +		ethernet1 = &eth1;

Hi Andrew,

I added these two aliases in v12, but kept your Reviewed-by for v11
because this is fairly trivial. Same for patch 5.

Is this okay?

Thanks,
Vivian "dramforever" Wang