[PATCH v3 1/3] PCI: microchip: Fix outbound address translation tables
daire.mcnamara at microchip.com
daire.mcnamara at microchip.com
Wed Jun 12 04:22:11 PDT 2024
From: Daire McNamara <daire.mcnamara at microchip.com>
On Microchip PolarFire SoC (MPFS) the PCIe Root Port can be behind one of
three general-purpose Fabric Interface Controller (FIC) buses that
encapsulate an AXI-M interface. That FIC is responsible for managing
the translations of the upper 32-bits of the AXI-M address. On MPFS,
the Root Port driver needs to take account of that outbound address
translation done by the parent FIC bus before setting up its own
outbound address translation tables. In all cases on MPFS,
the remaining outbound address translation tables are 32-bit only.
Limit the outbound address translation tables to 32-bit only.
Fixes: 6f15a9c9f941 ("PCI: microchip: Add Microchip Polarfire PCIe controller driver")
Signed-off-by: Daire McNamara <daire.mcnamara at microchip.com>
---
drivers/pci/controller/pcie-microchip-host.c | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/drivers/pci/controller/pcie-microchip-host.c b/drivers/pci/controller/pcie-microchip-host.c
index 137fb8570ba2..853adce24492 100644
--- a/drivers/pci/controller/pcie-microchip-host.c
+++ b/drivers/pci/controller/pcie-microchip-host.c
@@ -933,7 +933,7 @@ static int mc_pcie_init_irq_domains(struct mc_pcie *port)
static void mc_pcie_setup_window(void __iomem *bridge_base_addr, u32 index,
phys_addr_t axi_addr, phys_addr_t pci_addr,
- size_t size)
+ u64 size)
{
u32 atr_sz = ilog2(size) - 1;
u32 val;
@@ -983,7 +983,8 @@ static int mc_pcie_setup_windows(struct platform_device *pdev,
if (resource_type(entry->res) == IORESOURCE_MEM) {
pci_addr = entry->res->start - entry->offset;
mc_pcie_setup_window(bridge_base_addr, index,
- entry->res->start, pci_addr,
+ entry->res->start & 0xffffffff,
+ pci_addr,
resource_size(entry->res));
index++;
}
@@ -1117,9 +1118,8 @@ static int mc_platform_init(struct pci_config_window *cfg)
int ret;
/* Configure address translation table 0 for PCIe config space */
- mc_pcie_setup_window(bridge_base_addr, 0, cfg->res.start,
- cfg->res.start,
- resource_size(&cfg->res));
+ mc_pcie_setup_window(bridge_base_addr, 0, cfg->res.start & 0xffffffff,
+ 0, resource_size(&cfg->res));
/* Need some fixups in config space */
mc_pcie_enable_msi(port, cfg->win);
--
2.34.1
More information about the linux-riscv
mailing list