[PATCH v4 3/3] riscv: dts: sophgo: Add SARADC description for Sophgo CV18XX

[Inochi Amaoto]

On Tue, Aug 13, 2024 at 09:45:53AM GMT, Chen Wang wrote:
> 
> On 2024/8/12 23:00, Thomas Bonnefille wrote:
> > Adds SARADC nodes for the common Successive Approximation Analog to
> > Digital Converter used in Sophgo CV18xx series SoC.
> > This patch adds two nodes for the two controllers the board, one in
> > the Active domain and the other in the No-Die domain.
> Where is the node for the No-die domain?

I have suggested Thomas not add the node for the RTC domain.
It is not clear that which clock is used for the RTC domain,
it will good to add this node after the RTC is implemented.

> > 
> > Signed-off-by: Thomas Bonnefille <thomas.bonnefille at bootlin.com>
> > ---
> >   arch/riscv/boot/dts/sophgo/cv18xx.dtsi | 20 ++++++++++++++++++++
> >   1 file changed, 20 insertions(+)
> > 
> > diff --git a/arch/riscv/boot/dts/sophgo/cv18xx.dtsi b/arch/riscv/boot/dts/sophgo/cv18xx.dtsi
> > index 891932ae470f..71a2618852fa 100644
> > --- a/arch/riscv/boot/dts/sophgo/cv18xx.dtsi
> > +++ b/arch/riscv/boot/dts/sophgo/cv18xx.dtsi
> > @@ -133,6 +133,26 @@ portd: gpio-controller at 0 {
> >   			};
> >   		};
> > +		saradc: adc at 30f0000 {
> > +			compatible = "sophgo,cv1800b-saradc";
> > +			reg = <0x030f0000 0x1000>;
> > +			clocks = <&clk CLK_SARADC>;
> > +			interrupts = <100 IRQ_TYPE_LEVEL_HIGH>;
> > +			#address-cells = <1>;
> > +			#size-cells = <0>;
> > +			status = "disabled";
> > +
> > +			channel at 0 {
> > +				reg = <0>;
> > +			};
> > +			channel at 1 {
> > +				reg = <1>;
> > +			};
> > +			channel at 2 {
> > +				reg = <2>;
> > +			};
> > +		};
> > +
> >   		i2c0: i2c at 4000000 {
> >   			compatible = "snps,designware-i2c";
> >   			reg = <0x04000000 0x10000>;
> >