[PATCH v9 3/3] riscv: Use PUD/P4D/PGD pages for the linear mapping
Andrew Jones
ajones at ventanamicro.com
Mon Mar 27 04:37:20 PDT 2023
On Mon, Mar 27, 2023 at 01:15:43PM +0200, Alexandre Ghiti wrote:
> Hi Andrew,
>
> On Mon, Mar 27, 2023 at 11:39 AM Andrew Jones <ajones at ventanamicro.com> wrote:
> >
> > On Fri, Mar 24, 2023 at 04:54:21PM +0100, Alexandre Ghiti wrote:
> > > During the early page table creation, we used to set the mapping for
> > > PAGE_OFFSET to the kernel load address: but the kernel load address is
> > > always offseted by PMD_SIZE which makes it impossible to use PUD/P4D/PGD
> > > pages as this physical address is not aligned on PUD/P4D/PGD size (whereas
> > > PAGE_OFFSET is).
> > >
> > > But actually we don't have to establish this mapping (ie set va_pa_offset)
> > > that early in the boot process because:
> > >
> > > - first, setup_vm installs a temporary kernel mapping and among other
> > > things, discovers the system memory,
> > > - then, setup_vm_final creates the final kernel mapping and takes
> > > advantage of the discovered system memory to create the linear
> > > mapping.
> > >
> > > During the first phase, we don't know the start of the system memory and
> > > then until the second phase is finished, we can't use the linear mapping at
> > > all and phys_to_virt/virt_to_phys translations must not be used because it
> > > would result in a different translation from the 'real' one once the final
> > > mapping is installed.
> > >
> > > So here we simply delay the initialization of va_pa_offset to after the
> > > system memory discovery. But to make sure noone uses the linear mapping
> > > before, we add some guard in the DEBUG_VIRTUAL config.
> > >
> > > Finally we can use PUD/P4D/PGD hugepages when possible, which will result
> > > in a better TLB utilization.
> > >
> > > Note that:
> > > - this does not apply to rv32 as the kernel mapping lies in the linear
> > > mapping.
> > > - we rely on the firmware to protect itself using PMP.
> > >
> > > Signed-off-by: Alexandre Ghiti <alexghiti at rivosinc.com>
> > > Acked-by: Rob Herring <robh at kernel.org> # DT bits
> > > ---
> > > arch/riscv/include/asm/page.h | 16 ++++++++++
> > > arch/riscv/mm/init.c | 58 +++++++++++++++++++++++++++++++----
> > > arch/riscv/mm/physaddr.c | 16 ++++++++++
> > > drivers/of/fdt.c | 11 ++++---
> > > 4 files changed, 90 insertions(+), 11 deletions(-)
> > >
> > > diff --git a/arch/riscv/include/asm/page.h b/arch/riscv/include/asm/page.h
> > > index 8dc686f549b6..ea1a0e237211 100644
> > > --- a/arch/riscv/include/asm/page.h
> > > +++ b/arch/riscv/include/asm/page.h
> > > @@ -90,6 +90,14 @@ typedef struct page *pgtable_t;
> > > #define PTE_FMT "%08lx"
> > > #endif
> > >
> > > +#ifdef CONFIG_64BIT
> > > +/*
> > > + * We override this value as its generic definition uses __pa too early in
> > > + * the boot process (before kernel_map.va_pa_offset is set).
> > > + */
> > > +#define MIN_MEMBLOCK_ADDR 0
> > > +#endif
> > > +
> > > #ifdef CONFIG_MMU
> > > #define ARCH_PFN_OFFSET (PFN_DOWN((unsigned long)phys_ram_base))
> > > #else
> > > @@ -121,7 +129,11 @@ extern phys_addr_t phys_ram_base;
> > > #define is_linear_mapping(x) \
> > > ((x) >= PAGE_OFFSET && (!IS_ENABLED(CONFIG_64BIT) || (x) < PAGE_OFFSET + KERN_VIRT_SIZE))
> > >
> > > +#ifndef CONFIG_DEBUG_VIRTUAL
> > > #define linear_mapping_pa_to_va(x) ((void *)((unsigned long)(x) + kernel_map.va_pa_offset))
> > > +#else
> > > +void *linear_mapping_pa_to_va(unsigned long x);
> > > +#endif
> > > #define kernel_mapping_pa_to_va(y) ({ \
> > > unsigned long _y = (unsigned long)(y); \
> > > (IS_ENABLED(CONFIG_XIP_KERNEL) && _y < phys_ram_base) ? \
> > > @@ -130,7 +142,11 @@ extern phys_addr_t phys_ram_base;
> > > })
> > > #define __pa_to_va_nodebug(x) linear_mapping_pa_to_va(x)
> > >
> > > +#ifndef CONFIG_DEBUG_VIRTUAL
> > > #define linear_mapping_va_to_pa(x) ((unsigned long)(x) - kernel_map.va_pa_offset)
> > > +#else
> > > +phys_addr_t linear_mapping_va_to_pa(unsigned long x);
> > > +#endif
> > > #define kernel_mapping_va_to_pa(y) ({ \
> > > unsigned long _y = (unsigned long)(y); \
> > > (IS_ENABLED(CONFIG_XIP_KERNEL) && _y < kernel_map.virt_addr + XIP_OFFSET) ? \
> > > diff --git a/arch/riscv/mm/init.c b/arch/riscv/mm/init.c
> > > index 3b37d8606920..f803671d18b2 100644
> > > --- a/arch/riscv/mm/init.c
> > > +++ b/arch/riscv/mm/init.c
> > > @@ -213,6 +213,14 @@ static void __init setup_bootmem(void)
> > > phys_ram_end = memblock_end_of_DRAM();
> > > if (!IS_ENABLED(CONFIG_XIP_KERNEL))
> > > phys_ram_base = memblock_start_of_DRAM();
> > > +
> > > + /*
> > > + * In 64-bit, any use of __va/__pa before this point is wrong as we
> > > + * did not know the start of DRAM before.
> > > + */
> > > + if (IS_ENABLED(CONFIG_64BIT))
> > > + kernel_map.va_pa_offset = PAGE_OFFSET - phys_ram_base;
> > > +
> > > /*
> > > * memblock allocator is not aware of the fact that last 4K bytes of
> > > * the addressable memory can not be mapped because of IS_ERR_VALUE
> > > @@ -667,9 +675,16 @@ void __init create_pgd_mapping(pgd_t *pgdp,
> > >
> > > static uintptr_t __init best_map_size(phys_addr_t base, phys_addr_t size)
> > > {
> > > - /* Upgrade to PMD_SIZE mappings whenever possible */
> > > - base &= PMD_SIZE - 1;
> > > - if (!base && size >= PMD_SIZE)
> > > + if (!(base & (PGDIR_SIZE - 1)) && size >= PGDIR_SIZE)
> > > + return PGDIR_SIZE;
> > > +
> > > + if (!(base & (P4D_SIZE - 1)) && size >= P4D_SIZE)
> > > + return P4D_SIZE;
> > > +
> > > + if (!(base & (PUD_SIZE - 1)) && size >= PUD_SIZE)
> > > + return PUD_SIZE;
> > > +
> > > + if (!(base & (PMD_SIZE - 1)) && size >= PMD_SIZE)
> > > return PMD_SIZE;
> > >
> > > return PAGE_SIZE;
> > > @@ -978,11 +993,22 @@ asmlinkage void __init setup_vm(uintptr_t dtb_pa)
> > > set_satp_mode();
> > > #endif
> > >
> > > - kernel_map.va_pa_offset = PAGE_OFFSET - kernel_map.phys_addr;
> > > + /*
> > > + * In 64-bit, we defer the setup of va_pa_offset to setup_bootmem,
> > > + * where we have the system memory layout: this allows us to align
> > > + * the physical and virtual mappings and then make use of PUD/P4D/PGD
> > > + * for the linear mapping. This is only possible because the kernel
> > > + * mapping lies outside the linear mapping.
> > > + * In 32-bit however, as the kernel resides in the linear mapping,
> > > + * setup_vm_final can not change the mapping established here,
> > > + * otherwise the same kernel addresses would get mapped to different
> > > + * physical addresses (if the start of dram is different from the
> > > + * kernel physical address start).
> > > + */
> > > + kernel_map.va_pa_offset = IS_ENABLED(CONFIG_64BIT) ?
> > > + 0UL : PAGE_OFFSET - kernel_map.phys_addr;
> > > kernel_map.va_kernel_pa_offset = kernel_map.virt_addr - kernel_map.phys_addr;
> > >
> > > - phys_ram_base = kernel_map.phys_addr;
> > > -
> > > /*
> > > * The default maximal physical memory size is KERN_VIRT_SIZE for 32-bit
> > > * kernel, whereas for 64-bit kernel, the end of the virtual address
> > > @@ -1106,6 +1132,17 @@ static void __init create_linear_mapping_page_table(void)
> > > phys_addr_t start, end;
> > > u64 i;
> > >
> > > +#ifdef CONFIG_STRICT_KERNEL_RWX
> > > + phys_addr_t ktext_start = __pa_symbol(_start);
> > > + phys_addr_t ktext_size = __init_data_begin - _start;
> > > + phys_addr_t krodata_start = __pa_symbol(__start_rodata);
> > > + phys_addr_t krodata_size = _data - __start_rodata;
> > > +
> > > + /* Isolate kernel text and rodata so they don't get mapped with a PUD */
> > > + memblock_mark_nomap(ktext_start, ktext_size);
> > > + memblock_mark_nomap(krodata_start, krodata_size);
> > > +#endif
> > > +
> > > /* Map all memory banks in the linear mapping */
> > > for_each_mem_range(i, &start, &end) {
> > > if (start >= end)
> > > @@ -1118,6 +1155,15 @@ static void __init create_linear_mapping_page_table(void)
> > >
> > > create_linear_mapping_range(start, end);
> > > }
> > > +
> > > +#ifdef CONFIG_STRICT_KERNEL_RWX
> > > + create_linear_mapping_range(ktext_start, ktext_start + ktext_size);
> > > + create_linear_mapping_range(krodata_start,
> > > + krodata_start + krodata_size);
> >
> > Just for my own education, it looks to me like the rodata is left writable
> > until the end of start_kernel(), when mark_rodata_ro() is called. Is that
> > correct?
>
> Yes, right before init is triggered, certainly that late because the
> rodata section embeds the "__ro_after_init" variables.
Ah, that indeed helps clarify why. Sounds good.
Thanks,
drew
More information about the linux-riscv
mailing list