[PATCH v5 12/12] riscv: dts: starfive: visionfive 2: Enable gmac device tree node

[Guo Samin]

在 2023/3/6 21:04:28, Emil Renner Berthing 写道:
> On Fri, 3 Mar 2023 at 10:01, Samin Guo <samin.guo at starfivetech.com> wrote:
>> From: Yanhong Wang <yanhong.wang at starfivetech.com>
>>
>> Update gmac device tree node status to okay.
>>
>> Signed-off-by: Yanhong Wang <yanhong.wang at starfivetech.com>
>> Signed-off-by: Samin Guo <samin.guo at starfivetech.com>
>> ---
>>  .../dts/starfive/jh7110-starfive-visionfive-2.dtsi     | 10 ++++++++++
>>  1 file changed, 10 insertions(+)
>>
>> diff --git a/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2.dtsi b/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2.dtsi
>> index c2aa8946a0f1..d1c409f40014 100644
>> --- a/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2.dtsi
>> +++ b/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2.dtsi
>> @@ -12,6 +12,8 @@
>>  / {
>>         aliases {
>>                 serial0 = &uart0;
>> +               ethernet0 = &gmac0;
>> +               ethernet1 = &gmac1;
> 
> Please sort these alphabetically.
Thanks, will fix.
> 
>>                 i2c0 = &i2c0;
>>                 i2c2 = &i2c2;
>>                 i2c5 = &i2c5;
>> @@ -92,6 +94,14 @@
>>         status = "okay";
>>  };
>>
>> +&gmac0 {
>> +       status = "okay";
>> +};
>> +
>> +&gmac1 {
>> +       status = "okay";
>> +};
> 
> Since you'll need to add to the gmac0 and gmac1 nodes in the board
> specific files too and it's only one line, consider just dropping this
> here and add the status = "okay" there instead.
> 
According to Andrew's suggestion, can I put the nodes of mdio and phy here?
>>  &i2c0 {
>>         clock-frequency = <100000>;
>>         i2c-sda-hold-time-ns = <300>;
>> --
>> 2.17.1
>>
>>
>> _______________________________________________
>> linux-riscv mailing list
>> linux-riscv at lists.infradead.org
>> http://lists.infradead.org/mailman/listinfo/linux-riscv

Best regards,
Samin
-- 
Best regards,
Samin