[PATCH V1 0/3] Revert huge-paged linear mapping and its related fixups

[Alexandre Ghiti]

Hi Song,

On Sun, Jun 25, 2023 at 4:10 PM Song Shuai <songshuaishuai at tinylab.org> wrote:
>
> We have encountered these two issues about huge-paged linear mapping since v6.4-rc1:
>
> 1. Bug report: kernel paniced when system hibernates[1]
>
> OpenSbi [v0.8,v1.3) set the PMP regions as !no-map, and the commit 3335068f8721
> ("riscv: Use PUD/P4D/PGD pages for the linear mapping") mapped them in linear mapping.
> The hibernation process attempted to save/restore these mapped regions resulting in access fault.
>
> This issue was temporarily fixed by commit ed309ce52218 ("RISC-V: mark hibernation as nonportable").
> But as Alex's RFC and Rob's response stats in another thread [2] ,
> "Hibernation is only one case. Speculative accesses could also occur."
> So this fixing commit seems not the perfect answer to this issue.
>
>
> 2. Bug report: kernel paniced while booting (with UEFI )[3]
>
> During the booting with UEFI, UEFI Memory Mapping overwrote the memblock.
> The phys_ram_base was set as the end address of mmoderes0 (like 0x80040000 for 256 KiB mmoderes0 at 80000000),
> which resulted the VA based on 2M-aligned PA was not 2M-aligned using va_pa_offset
> (PAGE_OFFSET - phys_ram_base) to translate.
>
> The best_map_size() from commit 3335068f8721 didn't check the virtual alignment
> before choosing a map size. and then a "VA hole" was created where page faults always occurred.
>
> This issue was fixed by commit 49a0a3731596 ("riscv: Check the virtual alignment before choosing a map size"),
> But this fixing commit has a side-effect ("the possible third one" as Alex said in this thread).
> There are numerous PTE allocations slowing down the boot time and consuming some system memory when UEFI booting
> (Note that it's not involved when booting directly with OpenSbi, where phys_ram_base is the 2M-aligned base of DRAM).
>
> In my test, compared with/out reverting both commit 49a0a3731596 and commit 3335068f8721,
> I must wait ~20s for the linear mapping creation and mem_init_print_info() reported ~8M extra reserved memory.

Indeed, phys_ram_base is not aligned on a 2MB boundary when booting
with EDK2, IIRC that's because the first chunk of memory at
0x8000_0000 is marked as UC and is then completely evicted.

>
> To eliminate this side-effect, We should find a way to align VA and PA on a 2MB boundary.
> The simplest way is reverting the commit 3335068f8721 ("riscv: Use PUD/P4D/PGD pages for the linear mapping").
>

I disagree, the simplest way is to align phys_ram_base on a 2MB
boundary, either by aligning to the upper boundary (and then wastes
memory, like we used to) or by aligning to the lower boundary (but I
want to make sure it works).

I'll come up with something tomorrow.

Thanks,

Alex

>
>
> Using PUD/P4D/PGD pages for the linear mapping to improve the performance is marginal from a recent talk [4]
> from Mike Rapoport. OpenSbi had marked all the PMP-protected regions as "no-map" [5] to practice this talk.
>
> For all those reasons, let's revert these related commits:
>
> - commit 3335068f8721 ("riscv: Use PUD/P4D/PGD pages for the linear mapping")
> - commit 49a0a3731596 ("riscv: Check the virtual alignment before choosing a map size")
> - commit ed309ce52218 ("RISC-V: mark hibernation as nonportable")
>
> [1]: https://lore.kernel.org/linux-riscv/CAAYs2=gQvkhTeioMmqRDVGjdtNF_vhB+vm_1dHJxPNi75YDQ_Q@mail.gmail.com/
> [2]: https://lore.kernel.org/linux-kernel/20230530080425.18612-1-alexghiti@rivosinc.com/
> [3]: https://lore.kernel.org/linux-riscv/tencent_7C3B580B47C1B17C16488EC1@qq.com/
> [4]: https://lwn.net/Articles/931406/
> [5]: https://github.com/riscv-software-src/opensbi/commit/8153b2622b08802cc542f30a1fcba407a5667ab9
>
> Song Shuai (3):
>   Revert "RISC-V: mark hibernation as nonportable"
>   Revert "riscv: Check the virtual alignment before choosing a map size"
>   Revert "riscv: Use PUD/P4D/PGD pages for the linear mapping"
>
>  arch/riscv/Kconfig            |  5 +---
>  arch/riscv/include/asm/page.h | 16 -------------
>  arch/riscv/mm/init.c          | 43 +++++++----------------------------
>  arch/riscv/mm/physaddr.c      | 16 -------------
>  drivers/of/fdt.c              | 11 ++++-----
>  5 files changed, 14 insertions(+), 77 deletions(-)
>
> --
> 2.20.1
>