[PATCH v2 00/12] PolarFire SoC reset controller & clock cleanups

Conor.Dooley at microchip.com Conor.Dooley at microchip.com
Wed Jul 20 06:46:25 PDT 2022


On 04/07/2022 13:15, Conor Dooley wrote:
> Hey all,
> I know I have not sat on the RFC I sent about the aux. bus parts
> for too long, but figured I'd just send the whole thing anyway to all
> lists etc.

Hey Stephen,

Any comments on the clk/auxdev side of this series?

Thanks,
Conor.

> 
> Kinda two things happening in this series, but I sent it together to
> ensure the second part would apply correctly.
> 
> The first is the reset controller that I promised after discovering the
> issue triggered by CONFIG_PM & the phy not coming up correctly. I have
> now removed all the messing with resets from clock enable/disable
> functions & now use the aux bus to set up a reset controller driver.
> Since I needed something to test it, I hooked up the reset for the
> Cadence MACB on PolarFire SoC. This has been split into a second series
> for v2:
> https://lore.kernel.org/all/20220704114511.1892332-1-conor.dooley@microchip.com/
> 
> The second part adds rate control for the MSS PLL clock, followed by
> some simplifications to the driver & conversions of some custom structs
> to the corresponding structs in the framework.
> 
> Thanks,
> Conor.
> 
> Changes since v1:
> - split off the net patches
> - clk: actually pass the spinlock to the converted dividers & gates
> - reset: added a spinlock around RMW access to registers
> - reset: switched to BIT(i) macros
> - reset: used local copies of some variables as pointed out by Philipp
> - reset: dropped the success printout
> 
> Conor Dooley (12):
>    dt-bindings: clk: microchip: mpfs: add reset controller support
>    clk: microchip: mpfs: add reset controller
>    reset: add polarfire soc reset support
>    MAINTAINERS: add polarfire soc reset controller
>    riscv: dts: microchip: add mpfs specific macb reset support
>    clk: microchip: mpfs: add module_authors entries
>    clk: microchip: mpfs: add MSS pll's set & round rate
>    clk: microchip: mpfs: move id & offset out of clock structs
>    clk: microchip: mpfs: simplify control reg access
>    clk: microchip: mpfs: delete 2 line mpfs_clk_register_foo()
>    clk: microchip: mpfs: convert cfg_clk to clk_divider
>    clk: microchip: mpfs: convert periph_clk to clk_gate
> 
>   .../bindings/clock/microchip,mpfs.yaml        |  17 +-
>   MAINTAINERS                                   |   1 +
>   arch/riscv/boot/dts/microchip/mpfs.dtsi       |   7 +-
>   drivers/clk/microchip/Kconfig                 |   1 +
>   drivers/clk/microchip/clk-mpfs.c              | 379 +++++++++---------
>   drivers/reset/Kconfig                         |   7 +
>   drivers/reset/Makefile                        |   2 +-
>   drivers/reset/reset-mpfs.c                    | 157 ++++++++
>   include/soc/microchip/mpfs.h                  |   8 +
>   9 files changed, 386 insertions(+), 193 deletions(-)
>   create mode 100644 drivers/reset/reset-mpfs.c
> 
> 
> base-commit: b13baccc3850ca8b8cccbf8ed9912dbaa0fdf7f3



More information about the linux-riscv mailing list