[PATCH 1/4] PCI: qcom: Move PHY init and add PHY reset call to align with HPG

[Kathiravan Thirumoorthy]

On 9/16/2026 11:34 AM, Qiang Yu wrote:
> HPG requires the controller/PHY GDSCs powered up and all controller/PHY
> clocks enabled first, then the controller's reset and the PHY's reset
> toggled together as a group, PARF_DEVICE_TYPE set right after, and the
> rest of the PARF/DBI config left until the PHY is ready.
>
> Make use of phy_init() and phy_reset(), and change the call flow to:
>
>    qcom_pcie_host_init():
>      phy_init()             (PHY GDSCs/regulators/clocks up)
>      qcom_pcie_ops::init:
>        enable controller clocks
>        assert controller reset
>        phy_reset()           (toggle the PHY's own reset)
>        deassert controller reset
>        write PARF_DEVICE_TYPE
>      phy_power_on()
>      qcom_pcie_ops::post_init  (rest of the PHY/PARF/DBI setup)
>
> phy_init() moves into qcom_pcie_host_init() and phy_exit() into
> qcom_pcie_host_deinit(), right before and right after they call
> qcom_pcie_ops::init/qcom_pcie_ops::deinit.
>
> Apply this to qcom_pcie_init_2_7_0()/_2_9_0()/_2_3_2()/_2_3_3().
> qcom_pcie_init_2_3_3() was enabling clocks after the reset deassert; move
> that ahead of the reset assert to match the same ordering. Also add or
> move the PARF_DEVICE_TYPE write to right after the reset group in each of
> those four functions.
>
> For most platforms phy_init()/phy_exit()/phy_reset() are no-ops against
> their phy_ops, so moving the calls around has no effect yet; the PHY's
> clocks/reset actually start being driven this way once a later PHY driver
> change implements phy_ops::init/phy_ops::exit/phy_ops::reset.
> phy-qcom-pcie2.c does implement phy_init()/phy_exit(), but moving the call
> site into qcom_pcie_host_init()/qcom_pcie_host_deinit() keeps them at the
> same point relative to that platform's own clock/reset programming, so its
> init sequence doesn't change either.
>
> Signed-off-by: Qiang Yu<qiang.yu at oss.qualcomm.com>
> ---
>   drivers/pci/controller/dwc/pcie-qcom.c | 165 +++++++++++++++++++++++++--------
>   1 file changed, 126 insertions(+), 39 deletions(-)

Verified the PCIe enumeration in IPQ9574 and IPQ5424 and it works fine. So,

Tested-by: Kathiravan Thirumoorthy 
<kathiravan.thirumoorthy at oss.qualcomm.com> #IPQ9574-RDP433, IPQ5424-RDP466