[PATCH v21 14/14] arm64: dts: qcom: kaanapali-mtp-camera-s5kjn5: Add DT overlay

[Hangxiang Ma]

On 10/21/2026 10:02 PM, Konrad Dybcio wrote:
> On 10/12/26 8:45 AM, Hangxiang Ma wrote:
>> Enable the S5KJN5 image sensor via CCI on Kaanapali MTP board.
>>
>> The Kaanapali MTP board connect S5KJN5 with QUP I2C bus by default. This
>> DTBO enables S5KJN5 on CCI-0 interface connected to the CSIPHY2 in four
>> lane mode on a rework camera module.
>>
>> Signed-off-by: Hangxiang Ma <hangxiang.ma at oss.qualcomm.com>
>> ---
> 
> [...]
> 
>> +&camss_csiphy2_in_port {
>> +	camss_csiphy2_inep: endpoint {
>> +		data-lanes = <1 2 3 4>;
>> +		remote-endpoint = <&csiphy2_out_ep>;
>> +	};
>> +};
> 
> Please define the endpoint in the SoC DTSI like the glymur submission:
> 
> https://lore.kernel.org/linux-arm-msm/b5734dac-1285-452b-8107-9164e6a3e5fa@oss.qualcomm.com/T/#m55a2d04f3fe573dbbc86fe89a874514494eca345
> 
> [...]
> 
> 
>> +&csiphy2_in_port {
>> +	csiphy2_in_ep: endpoint {
>> +		bus-type = <MEDIA_BUS_TYPE_CSI2_DPHY>;
>> +		clock-lanes = <0>;
>> +		data-lanes = <1 2 3 4>;
>> +		remote-endpoint = <&s5kjn5_out_ep>;
>> +	};
>> +};
>> +
>> +&csiphy2_out_port {
>> +	csiphy2_out_ep: endpoint {
>> +		remote-endpoint = <&camss_csiphy2_inep>;
>> +	};
>> +};
> 
> likewise for these two
> 
> With that:
> 
> Reviewed-by: Konrad Dybcio <konrad.dybcio at oss.qualcomm.com>
> 
> Konrad

Ack

---
Best Regards,
Hangxiang