[PATCH v21 14/14] arm64: dts: qcom: kaanapali-mtp-camera-s5kjn5: Add DT overlay

[Konrad Dybcio]

On 10/12/26 8:45 AM, Hangxiang Ma wrote:
> Enable the S5KJN5 image sensor via CCI on Kaanapali MTP board.
> 
> The Kaanapali MTP board connect S5KJN5 with QUP I2C bus by default. This
> DTBO enables S5KJN5 on CCI-0 interface connected to the CSIPHY2 in four
> lane mode on a rework camera module.
> 
> Signed-off-by: Hangxiang Ma <hangxiang.ma at oss.qualcomm.com>
> ---

[...]

> +&camss_csiphy2_in_port {
> +	camss_csiphy2_inep: endpoint {
> +		data-lanes = <1 2 3 4>;
> +		remote-endpoint = <&csiphy2_out_ep>;
> +	};
> +};

Please define the endpoint in the SoC DTSI like the glymur submission:

https://lore.kernel.org/linux-arm-msm/b5734dac-1285-452b-8107-9164e6a3e5fa@oss.qualcomm.com/T/#m55a2d04f3fe573dbbc86fe89a874514494eca345

[...]


> +&csiphy2_in_port {
> +	csiphy2_in_ep: endpoint {
> +		bus-type = <MEDIA_BUS_TYPE_CSI2_DPHY>;
> +		clock-lanes = <0>;
> +		data-lanes = <1 2 3 4>;
> +		remote-endpoint = <&s5kjn5_out_ep>;
> +	};
> +};
> +
> +&csiphy2_out_port {
> +	csiphy2_out_ep: endpoint {
> +		remote-endpoint = <&camss_csiphy2_inep>;
> +	};
> +};

likewise for these two

With that:

Reviewed-by: Konrad Dybcio <konrad.dybcio at oss.qualcomm.com>

Konrad