[PATCH 10/15] arm64: dts: mediatek: mt7981b: Add Ethernet and WiFi offload support

[Sjoerd Simons]

On Thu, 2025-10-16 at 17:47 +0100, Daniel Golle wrote:
> On Thu, Oct 16, 2025 at 12:08:46PM +0200, Sjoerd Simons wrote:
> > Add device tree nodes for the Ethernet subsystem on MT7981B SoC,
> > including:
> > - Ethernet MAC controller with dual GMAC support
> > - Wireless Ethernet Dispatch (WED)
> > - SGMII PHY controllers for high-speed Ethernet interfaces
> > - Reserved memory regions for WiFi offload processor
> > 
> > Signed-off-by: Sjoerd Simons <sjoerd at collabora.com>
> > ---
> >  arch/arm64/boot/dts/mediatek/mt7981b.dtsi | 133 ++++++++++++++++++++++++++++++
> >  1 file changed, 133 insertions(+)
> > 
> > diff --git a/arch/arm64/boot/dts/mediatek/mt7981b.dtsi
> > b/arch/arm64/boot/dts/mediatek/mt7981b.dtsi
> > index 13950fe6e8766..c85fa0ddf2da8 100644
> > --- a/arch/arm64/boot/dts/mediatek/mt7981b.dtsi
> > +++ b/arch/arm64/boot/dts/mediatek/mt7981b.dtsi

[snip]
> > 			mdio_bus: mdio-bus {
> > +				#address-cells = <1>;
> > +				#size-cells = <0>;
> > +
> > +				int_gbe_phy: ethernet-phy at 0 {
> > +					compatible = "ethernet-phy-ieee802.3-c22";
> > +					reg = <0>;
> > +					phy-mode = "gmii";
> > +					phy-is-integrated;
> > +					nvmem-cells = <&phy_calibration>;
> > +					nvmem-cell-names = "phy-cal-data";
> 
> Please also define the two LEDs here with their corresponding (only)
> pinctrl options for each of them, with 'status = "disabled";'. This
> makes it easier for boards to make use of the Ethernet PHY leds by just
> referencing the LED and setting the status to 'okay'.

I left those out on purpose as i can't easily validate them. They're probably better to be added once
someone adds a board using the hw led control.

> 
-- 
Sjoerd Simons
Collabora Ltd.