[PATCH 11/15] arm64: dts: mediatek: mt7981b-openwrt-one: Enable SPI NOR
Sjoerd Simons
sjoerd at collabora.com
Thu Oct 16 03:08:47 PDT 2025
The openwrt one has a SPI NOR flash which from factory is used for:
* Recovery system
* WiFi eeprom data
* ethernet Mac addresses
Describe this following the same partitions as the openwrt configuration
uses.
Signed-off-by: Sjoerd Simons <sjoerd at collabora.com>
---
.../boot/dts/mediatek/mt7981b-openwrt-one.dts | 83 ++++++++++++++++++++++
1 file changed, 83 insertions(+)
diff --git a/arch/arm64/boot/dts/mediatek/mt7981b-openwrt-one.dts b/arch/arm64/boot/dts/mediatek/mt7981b-openwrt-one.dts
index b6ca628ee72fd..9878009385cc6 100644
--- a/arch/arm64/boot/dts/mediatek/mt7981b-openwrt-one.dts
+++ b/arch/arm64/boot/dts/mediatek/mt7981b-openwrt-one.dts
@@ -3,6 +3,7 @@
/dts-v1/;
#include "mt7981b.dtsi"
+#include "dt-bindings/pinctrl/mt65xx.h"
/ {
compatible = "openwrt,one", "mediatek,mt7981b";
@@ -54,6 +55,25 @@ mux {
};
};
+ spi2_flash_pins: spi2-pins {
+ mux {
+ function = "spi";
+ groups = "spi2";
+ };
+
+ conf-pu {
+ bias-pull-up = <MTK_PUPD_SET_R1R0_11>;
+ drive-strength = <MTK_DRIVE_8mA>;
+ pins = "SPI2_CS", "SPI2_WP";
+ };
+
+ conf-pd {
+ bias-pull-down = <MTK_PUPD_SET_R1R0_11>;
+ drive-strength = <MTK_DRIVE_8mA>;
+ pins = "SPI2_CLK", "SPI2_MOSI", "SPI2_MISO";
+ };
+ };
+
uart0_pins: uart0-pins {
mux {
function = "uart";
@@ -62,6 +82,69 @@ mux {
};
};
+&spi2 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&spi2_flash_pins>;
+ status = "okay";
+
+ flash at 0 {
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <40000000>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition at 0 {
+ reg = <0x00000 0x40000>;
+ label = "bl2-nor";
+ };
+
+ partition at 40000 {
+ reg = <0x40000 0xc0000>;
+ label = "factory";
+ read-only;
+
+ nvmem-layout {
+ compatible = "fixed-layout";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ eeprom_factory_0: eeprom at 0 {
+ reg = <0x0 0x1000>;
+ };
+
+ macaddr_factory_4: macaddr at 4 {
+ reg = <0x4 0x6>;
+ compatible = "mac-base";
+ #nvmem-cell-cells = <1>;
+ };
+
+ macaddr_factory_24: macaddr at 24 {
+ reg = <0x24 0x6>;
+ compatible = "mac-base";
+ #nvmem-cell-cells = <1>;
+ };
+ };
+ };
+
+ partition at 100000 {
+ reg = <0x100000 0x80000>;
+ label = "fip-nor";
+ };
+
+ partition at 180000 {
+ reg = <0x180000 0xc80000>;
+ label = "recovery";
+ };
+ };
+ };
+};
+
&uart0 {
pinctrl-names = "default";
pinctrl-0 = <&uart0_pins>;
--
2.51.0
More information about the linux-phy
mailing list