[PATCH 4/4] phy: qualcomm: phy-qcom-eusb2-repeater: Add support for PMIV0104

[neil.armstrong at linaro.org]

On 25/06/2025 11:14, Luca Weiss wrote:
> Add support for the eUSB2 repeater found on the PMIV0104. There is no
> default init table for this PMIC, just the board-specific tuning
> parameters are used on top of the default tuning values.
> 
> Signed-off-by: Luca Weiss <luca.weiss at fairphone.com>
> ---
>   drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c | 12 ++++++++++++
>   1 file changed, 12 insertions(+)
> 
> diff --git a/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c b/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
> index 61594739e5b12706775622e1f76af6ad5d2d29bf..3d4cdc4c18becd8efd5015e698b836ad4d7cf18c 100644
> --- a/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
> +++ b/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
> @@ -82,6 +82,14 @@ static const struct eusb2_repeater_cfg pm8550b_eusb2_cfg = {
>   	.num_vregs	= ARRAY_SIZE(pm8550b_vreg_l),
>   };
>   
> +static const struct eusb2_repeater_cfg pmiv0104_eusb2_cfg = {
> +	/* No PMIC-specific init sequence, only board level tuning via DT */
> +	.init_tbl	= (struct eusb2_repeater_init_tbl_reg[]) {},
> +	.init_tbl_num	= 0,
> +	.vreg_list	= pm8550b_vreg_l,
> +	.num_vregs	= ARRAY_SIZE(pm8550b_vreg_l),
> +};
> +
>   static const struct eusb2_repeater_cfg smb2360_eusb2_cfg = {
>   	.init_tbl	= smb2360_init_tbl,
>   	.init_tbl_num	= ARRAY_SIZE(smb2360_init_tbl),
> @@ -264,6 +272,10 @@ static const struct of_device_id eusb2_repeater_of_match_table[] = {
>   		.compatible = "qcom,pm8550b-eusb2-repeater",
>   		.data = &pm8550b_eusb2_cfg,
>   	},
> +	{
> +		.compatible = "qcom,pmiv0104-eusb2-repeater",
> +		.data = &pmiv0104_eusb2_cfg,
> +	},
>   	{
>   		.compatible = "qcom,smb2360-eusb2-repeater",
>   		.data = &smb2360_eusb2_cfg,
> 

Reviewed-by: Neil Armstrong <neil.armstrong at linaro.org>