[PATCH v2 4/4] phy: qualcomm: phy-qcom-eusb2-repeater: Add support for PMIV0104
Konrad Dybcio
konrad.dybcio at oss.qualcomm.com
Fri Jul 11 05:27:11 PDT 2025
On 7/9/25 4:55 PM, Luca Weiss wrote:
> Add support for the eUSB2 repeater found on the PMIV0104. There is no
> default init table for this PMIC, just the board-specific tuning
> parameters are used on top of the default tuning values.
>
> Reviewed-by: Abel Vesa <abel.vesa at linaro.org>
> Reviewed-by: Neil Armstrong <neil.armstrong at linaro.org>
> Signed-off-by: Luca Weiss <luca.weiss at fairphone.com>
> ---
> drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c | 12 ++++++++++++
> 1 file changed, 12 insertions(+)
>
> diff --git a/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c b/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
> index 61594739e5b12706775622e1f76af6ad5d2d29bf..3d4cdc4c18becd8efd5015e698b836ad4d7cf18c 100644
> --- a/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
> +++ b/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
> @@ -82,6 +82,14 @@ static const struct eusb2_repeater_cfg pm8550b_eusb2_cfg = {
> .num_vregs = ARRAY_SIZE(pm8550b_vreg_l),
> };
>
> +static const struct eusb2_repeater_cfg pmiv0104_eusb2_cfg = {
> + /* No PMIC-specific init sequence, only board level tuning via DT */
> + .init_tbl = (struct eusb2_repeater_init_tbl_reg[]) {},
> + .init_tbl_num = 0,
NULL / omitted fields would be fine too fwiw
Konrad
More information about the linux-phy
mailing list