[PATCH v2 4/4] phy: qualcomm: phy-qcom-eusb2-repeater: Add support for PMIV0104

[Luca Weiss]

Add support for the eUSB2 repeater found on the PMIV0104. There is no
default init table for this PMIC, just the board-specific tuning
parameters are used on top of the default tuning values.

Reviewed-by: Abel Vesa <abel.vesa at linaro.org>
Reviewed-by: Neil Armstrong <neil.armstrong at linaro.org>
Signed-off-by: Luca Weiss <luca.weiss at fairphone.com>
---
 drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c b/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
index 61594739e5b12706775622e1f76af6ad5d2d29bf..3d4cdc4c18becd8efd5015e698b836ad4d7cf18c 100644
--- a/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
+++ b/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
@@ -82,6 +82,14 @@ static const struct eusb2_repeater_cfg pm8550b_eusb2_cfg = {
 	.num_vregs	= ARRAY_SIZE(pm8550b_vreg_l),
 };
 
+static const struct eusb2_repeater_cfg pmiv0104_eusb2_cfg = {
+	/* No PMIC-specific init sequence, only board level tuning via DT */
+	.init_tbl	= (struct eusb2_repeater_init_tbl_reg[]) {},
+	.init_tbl_num	= 0,
+	.vreg_list	= pm8550b_vreg_l,
+	.num_vregs	= ARRAY_SIZE(pm8550b_vreg_l),
+};
+
 static const struct eusb2_repeater_cfg smb2360_eusb2_cfg = {
 	.init_tbl	= smb2360_init_tbl,
 	.init_tbl_num	= ARRAY_SIZE(smb2360_init_tbl),
@@ -264,6 +272,10 @@ static const struct of_device_id eusb2_repeater_of_match_table[] = {
 		.compatible = "qcom,pm8550b-eusb2-repeater",
 		.data = &pm8550b_eusb2_cfg,
 	},
+	{
+		.compatible = "qcom,pmiv0104-eusb2-repeater",
+		.data = &pmiv0104_eusb2_cfg,
+	},
 	{
 		.compatible = "qcom,smb2360-eusb2-repeater",
 		.data = &smb2360_eusb2_cfg,

-- 
2.50.0