[PATCH V2 3/4] arm64: dts: qcom: hamoa: Add UFS nodes for x1e80100 SoC
Pradeep P V K
pradeep.pragallapati at oss.qualcomm.com
Wed Dec 31 02:19:50 PST 2025
Add UFS host controller and PHY nodes for x1e80100 SoC.
Signed-off-by: Pradeep P V K <pradeep.pragallapati at oss.qualcomm.com>
---
arch/arm64/boot/dts/qcom/hamoa.dtsi | 123 +++++++++++++++++++++++++++-
1 file changed, 120 insertions(+), 3 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/hamoa.dtsi b/arch/arm64/boot/dts/qcom/hamoa.dtsi
index 21ab6ef61520..cd7e2f130fe2 100644
--- a/arch/arm64/boot/dts/qcom/hamoa.dtsi
+++ b/arch/arm64/boot/dts/qcom/hamoa.dtsi
@@ -835,9 +835,9 @@ gcc: clock-controller at 100000 {
<0>,
<0>,
<0>,
- <0>,
- <0>,
- <0>;
+ <&ufs_mem_phy 0>,
+ <&ufs_mem_phy 1>,
+ <&ufs_mem_phy 2>;
power-domains = <&rpmhpd RPMHPD_CX>;
#clock-cells = <1>;
@@ -3848,6 +3848,123 @@ pcie4_phy: phy at 1c0e000 {
status = "disabled";
};
+ ufs_mem_phy: phy at 1d80000 {
+ compatible = "qcom,x1e80100-qmp-ufs-phy",
+ "qcom,sm8550-qmp-ufs-phy";
+ reg = <0x0 0x01d80000 0x0 0x2000>;
+
+ clocks = <&rpmhcc RPMH_CXO_CLK>,
+ <&gcc GCC_UFS_PHY_PHY_AUX_CLK>,
+ <&tcsr TCSR_UFS_PHY_CLKREF_EN>;
+
+ clock-names = "ref",
+ "ref_aux",
+ "qref";
+ resets = <&ufs_mem_hc 0>;
+ reset-names = "ufsphy";
+
+ power-domains = <&gcc GCC_UFS_MEM_PHY_GDSC>;
+
+ #clock-cells = <1>;
+ #phy-cells = <0>;
+
+ status = "disabled";
+ };
+
+ ufs_mem_hc: ufs at 1d84000 {
+ compatible = "qcom,x1e80100-ufshc",
+ "qcom,sm8550-ufshc",
+ "qcom,ufshc",
+ "jedec,ufs-2.0";
+ reg = <0x0 0x01d84000 0x0 0x3000>;
+
+ interrupts = <GIC_SPI 265 IRQ_TYPE_LEVEL_HIGH>;
+
+ clocks = <&gcc GCC_UFS_PHY_AXI_CLK>,
+ <&gcc GCC_AGGRE_UFS_PHY_AXI_CLK>,
+ <&gcc GCC_UFS_PHY_AHB_CLK>,
+ <&gcc GCC_UFS_PHY_UNIPRO_CORE_CLK>,
+ <&rpmhcc RPMH_LN_BB_CLK3>,
+ <&gcc GCC_UFS_PHY_TX_SYMBOL_0_CLK>,
+ <&gcc GCC_UFS_PHY_RX_SYMBOL_0_CLK>,
+ <&gcc GCC_UFS_PHY_RX_SYMBOL_1_CLK>;
+ clock-names = "core_clk",
+ "bus_aggr_clk",
+ "iface_clk",
+ "core_clk_unipro",
+ "ref_clk",
+ "tx_lane0_sync_clk",
+ "rx_lane0_sync_clk",
+ "rx_lane1_sync_clk";
+
+ operating-points-v2 = <&ufs_opp_table>;
+
+ resets = <&gcc GCC_UFS_PHY_BCR>;
+ reset-names = "rst";
+
+ interconnects = <&aggre1_noc MASTER_UFS_MEM QCOM_ICC_TAG_ALWAYS
+ &mc_virt SLAVE_EBI1 QCOM_ICC_TAG_ALWAYS>,
+ <&gem_noc MASTER_APPSS_PROC QCOM_ICC_TAG_ACTIVE_ONLY
+ &config_noc SLAVE_UFS_MEM_CFG QCOM_ICC_TAG_ACTIVE_ONLY>;
+ interconnect-names = "ufs-ddr",
+ "cpu-ufs";
+
+ power-domains = <&gcc GCC_UFS_PHY_GDSC>;
+ required-opps = <&rpmhpd_opp_nom>;
+
+ iommus = <&apps_smmu 0x1a0 0>;
+ dma-coherent;
+
+ lanes-per-direction = <2>;
+
+ phys = <&ufs_mem_phy>;
+ phy-names = "ufsphy";
+
+ #reset-cells = <1>;
+
+ status = "disabled";
+
+ ufs_opp_table: opp-table {
+ compatible = "operating-points-v2";
+
+ opp-75000000 {
+ opp-hz = /bits/ 64 <75000000>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <75000000>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>;
+ required-opps = <&rpmhpd_opp_low_svs>;
+ };
+
+ opp-150000000 {
+ opp-hz = /bits/ 64 <150000000>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <150000000>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>;
+ required-opps = <&rpmhpd_opp_svs>;
+ };
+
+ opp-300000000 {
+ opp-hz = /bits/ 64 <300000000>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <300000000>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>,
+ /bits/ 64 <0>;
+ required-opps = <&rpmhpd_opp_nom>;
+ };
+ };
+ };
+
cryptobam: dma-controller at 1dc4000 {
compatible = "qcom,bam-v1.7.4", "qcom,bam-v1.7.0";
reg = <0x0 0x01dc4000 0x0 0x28000>;
--
2.34.1
More information about the linux-phy
mailing list