[PATCH v3 1/3] dt-bindings: phy: qcom,snps-eusb2-repeater: Add squelch param update

[Vinod Koul]

On 23-12-25, 15:16, Krzysztof Kozlowski wrote:
> On 23/12/2025 15:11, Vinod Koul wrote:
> > On 19-12-25, 23:01, Krishna Kurapati wrote:
> >> Add squelch detect parameter update for synopsys eusb2 repeater. The
> >> values (indicated in basis-points) depict a percentage change with
> >> respect to the nominal value.
> >>
> >> Signed-off-by: Krishna Kurapati <krishna.kurapati at oss.qualcomm.com>
> >> Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski at oss.qualcomm.com>
> >> ---
> >>  .../devicetree/bindings/phy/qcom,snps-eusb2-repeater.yaml | 8 ++++++++
> >>  1 file changed, 8 insertions(+)
> >>
> >> diff --git a/Documentation/devicetree/bindings/phy/qcom,snps-eusb2-repeater.yaml b/Documentation/devicetree/bindings/phy/qcom,snps-eusb2-repeater.yaml
> >> index 5bf0d6c9c025..f2afcf0e986a 100644
> >> --- a/Documentation/devicetree/bindings/phy/qcom,snps-eusb2-repeater.yaml
> >> +++ b/Documentation/devicetree/bindings/phy/qcom,snps-eusb2-repeater.yaml
> >> @@ -59,6 +59,14 @@ properties:
> >>      minimum: 0
> >>      maximum: 7
> >>  
> >> +  qcom,squelch-detector-bp:
> >> +    description:
> >> +      This adjusts the voltage level for the threshold used to detect valid
> >> +      high-speed data.
> >> +    minimum: -6000
> > 
> > 6000Volts, mV, can you please document the units?
> 
> 
> Code is correct, the '-bp' is the unit here. Unless the suffix was
> chosen incorrectly?

I was hoping it will be commented in the description here.
For my reference, what is bp and where is it documented ?

> 
> 
> Best regards,
> Krzysztof

-- 
~Vinod