[PATCH v2] dt-bindings: phy: ti,tcan104x-can: Document TI TCAN1046

[Marc Kleine-Budde]

On 10.12.2025 18:21:34, Conor Dooley wrote:
> On Wed, Dec 10, 2025 at 08:52:58AM +0100, Marc Kleine-Budde wrote:
> > On 09.12.2025 16:21:19, Prabhakar wrote:
> > > From: Lad Prabhakar <prabhakar.mahadev-lad.rj at bp.renesas.com>
> > >
> > > Document the TI TCAN1046 automotive CAN transceiver. The TCAN1046 is a
> > > dual high-speed CAN transceiver with sleep-mode support and no EN pin,
> > > mirroring the behaviour of the NXP TJA1048, which also provides dual
> > > channels and STB1/2 sleep-control lines.
> > >
> > > Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj at bp.renesas.com>
> > > ---
> > > TCAN 1046, https://www.ti.com/lit/ds/symlink/tcan1046v-q1.pdf?ts=1765297159307&ref_url=https%253A%252F%252Fwww.ti.com%252Fproduct%252FTCAN1046V-Q1
> > > NXP TJA1048, https://www.nxp.com/docs/en/data-sheet/TJA1048.pdf
> >
> > The polarity of the standby line of the chips is different.
> >
> > You must set the correct active high/low property for the GPIO, as the
> > driver uses logical levels.
> >
> > Reviewed-by: Marc Kleine-Budde <mkl at pengutronix.de>
>
> What you're saying seems to contradict the tag you've given, is a
> fallback really suitable if the standby polarity is not the same?

The driver uses _logical_ levels to switch the GPIOs. For example to
power on the PHY, it disables the standby GPIO by setting the value to
"0".

| static int can_transceiver_phy_power_on(struct phy *phy)
| {
[...]
|         gpiod_set_value_cansleep(can_transceiver_phy->standby_gpio, 0);
[...]
| }

You have to use GPIO_ACTIVE_HIGH/GPIO_ACTIVE_LOW in the DT to configure
the actual level of the GPIO.

If you connect the PHY's standby input directly to the SoC's GPIO....

| TJA1048: HIGH = Normal mode, LOW = Standby mode
| TCAN1046: High = Standby mode, Low = Normal Mode

...for the TJA1048 you would use GPIO_ACTIVE_LOW, while for the
TCAN1046 you would use GPIO_ACTIVE_HIGH.

regards,
Marc

-- 
Pengutronix e.K.                 | Marc Kleine-Budde          |
Embedded Linux                   | https://www.pengutronix.de |
Vertretung Nürnberg              | Phone: +49-5121-206917-129 |
Amtsgericht Hildesheim, HRA 2686 | Fax:   +49-5121-206917-9   |
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 488 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-phy/attachments/20251212/ee85dfbf/attachment.sig>