[PATCH] phy: qualcomm: phy-qcom-eusb2-repeater: fix override properties

[Luca Weiss]

On Tue Aug 12, 2025 at 11:39 AM CEST, Pengyu Luo wrote:
> property "qcom,tune-usb2-preem" is for EUSB2_TUNE_USB2_PREEM
> property "qcom,tune-usb2-amplitude" is for EUSB2_TUNE_IUSB2
>
> The downstream correspondence is as follows:
> EUSB2_TUNE_USB2_PREEM: Tx pre-emphasis tuning
> EUSB2_TUNE_IUSB2: HS trasmit amplitude
> EUSB2_TUNE_SQUELCH_U: Squelch detection threshold
> EUSB2_TUNE_HSDISC: HS disconnect threshold
> EUSB2_TUNE_EUSB_SLEW: slew rate
>
> Fixes: 31bc94de7602 ("phy: qualcomm: phy-qcom-eusb2-repeater: Don't zero-out registers")

Oh, not sure how this happened. Thanks for catching this, I do see the
problem in my original commit.

Reviewed-by: Luca Weiss <luca.weiss at fairphone.com>

Regards
Luca

> Signed-off-by: Pengyu Luo <mitltlatltl at gmail.com>
> ---
>  drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c b/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
> index d7493c229..3709fba42 100644
> --- a/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
> +++ b/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
> @@ -127,13 +127,13 @@ static int eusb2_repeater_init(struct phy *phy)
>  			     rptr->cfg->init_tbl[i].value);
>  
>  	/* Override registers from devicetree values */
> -	if (!of_property_read_u8(np, "qcom,tune-usb2-amplitude", &val))
> +	if (!of_property_read_u8(np, "qcom,tune-usb2-preem", &val))
>  		regmap_write(regmap, base + EUSB2_TUNE_USB2_PREEM, val);
>  
>  	if (!of_property_read_u8(np, "qcom,tune-usb2-disc-thres", &val))
>  		regmap_write(regmap, base + EUSB2_TUNE_HSDISC, val);
>  
> -	if (!of_property_read_u8(np, "qcom,tune-usb2-preem", &val))
> +	if (!of_property_read_u8(np, "qcom,tune-usb2-amplitude", &val))
>  		regmap_write(regmap, base + EUSB2_TUNE_IUSB2, val);
>  
>  	/* Wait for status OK */