[PATCH v4 5/6] phy: qcom: qmp-combo: register a typec mux to change the QMPPHY_MODE

[Konrad Dybcio]

On 8/9/25 10:13 AM, Dmitry Baryshkov wrote:
> On Thu, Aug 07, 2025 at 06:33:23PM +0200, Konrad Dybcio wrote:
>> From: Neil Armstrong <neil.armstrong at linaro.org>
>>
>> Register a typec mux in order to change the PHY mode on the Type-C
>> mux events depending on the mode and the svid when in Altmode setup.
>>
>> The DisplayPort phy should be left enabled if is still powered on
>> by the DRM DisplayPort controller, so bail out until the DisplayPort
>> PHY is not powered off.
>>
>> The Type-C Mode/SVID only changes on plug/unplug, and USB SAFE states
>> will be set in between of USB-Only, Combo and DisplayPort Only so
>> this will leave enough time to the DRM DisplayPort controller to
>> turn of the DisplayPort PHY.
>>
>> Signed-off-by: Neil Armstrong <neil.armstrong at linaro.org>
>> [konrad: renaming, rewording, bug fixes]
>> Signed-off-by: Konrad Dybcio <konrad.dybcio at oss.qualcomm.com>
>> ---
>>  drivers/phy/qualcomm/phy-qcom-qmp-combo.c | 118 ++++++++++++++++++++++++++++--
>>  1 file changed, 113 insertions(+), 5 deletions(-)
>>
>> +
>> +	if (qmp->qmpphy_mode != QMPPHY_MODE_USB3_ONLY && qmp->dp_powered_on) {
>> +		dev_dbg(qmp->dev, "typec_mux_set: DP PHY is still in use, delaying switch\n");
>> +		return 0;
>> +	}
> 
> I can't say that I'm fully happy about it, nevertheless:
> 
> Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at oss.qualcomm.com>

IIUC we'll be able to get rid of it after the dp rework?

Konrad