[PATCH v4 6/6] arm64: dts: qcom: x1e80100: Add support for PCIe3 on x1e80100
Manivannan Sadhasivam
manivannan.sadhasivam at linaro.org
Tue Sep 24 07:06:18 PDT 2024
On Tue, Sep 24, 2024 at 03:14:44AM -0700, Qiang Yu wrote:
> Describe PCIe3 controller and PHY. Also add required system resources like
> regulators, clocks, interrupts and registers configuration for PCIe3.
>
> Signed-off-by: Qiang Yu <quic_qianyu at quicinc.com>
Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam at linaro.org>
- Mani
> Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
> ---
> arch/arm64/boot/dts/qcom/x1e80100.dtsi | 204 ++++++++++++++++++++++++-
> 1 file changed, 203 insertions(+), 1 deletion(-)
>
> diff --git a/arch/arm64/boot/dts/qcom/x1e80100.dtsi b/arch/arm64/boot/dts/qcom/x1e80100.dtsi
> index a36076e3c56b..c615c930cf0c 100644
> --- a/arch/arm64/boot/dts/qcom/x1e80100.dtsi
> +++ b/arch/arm64/boot/dts/qcom/x1e80100.dtsi
> @@ -744,7 +744,7 @@ gcc: clock-controller at 100000 {
>
> clocks = <&bi_tcxo_div2>,
> <&sleep_clk>,
> - <0>,
> + <&pcie3_phy>,
> <&pcie4_phy>,
> <&pcie5_phy>,
> <&pcie6a_phy>,
> @@ -2907,6 +2907,208 @@ mmss_noc: interconnect at 1780000 {
> #interconnect-cells = <2>;
> };
>
> + pcie3: pcie at 1bd0000 {
> + device_type = "pci";
> + compatible = "qcom,pcie-x1e80100";
> + reg = <0x0 0x01bd0000 0x0 0x3000>,
> + <0x0 0x78000000 0x0 0xf1d>,
> + <0x0 0x78000f40 0x0 0xa8>,
> + <0x0 0x78001000 0x0 0x1000>,
> + <0x0 0x78100000 0x0 0x100000>,
> + <0x0 0x01bd3000 0x0 0x1000>;
> + reg-names = "parf",
> + "dbi",
> + "elbi",
> + "atu",
> + "config",
> + "mhi";
> + #address-cells = <3>;
> + #size-cells = <2>;
> + ranges = <0x01000000 0x0 0x00000000 0x0 0x78200000 0x0 0x100000>,
> + <0x02000000 0x0 0x78300000 0x0 0x78300000 0x0 0x3d00000>,
> + <0x03000000 0x7 0x40000000 0x7 0x40000000 0x0 0x40000000>;
> + bus-range = <0x00 0xff>;
> +
> + dma-coherent;
> +
> + linux,pci-domain = <3>;
> + num-lanes = <8>;
> +
> + interrupts = <GIC_SPI 158 IRQ_TYPE_LEVEL_HIGH>,
> + <GIC_SPI 166 IRQ_TYPE_LEVEL_HIGH>,
> + <GIC_SPI 769 IRQ_TYPE_LEVEL_HIGH>,
> + <GIC_SPI 836 IRQ_TYPE_LEVEL_HIGH>,
> + <GIC_SPI 671 IRQ_TYPE_LEVEL_HIGH>,
> + <GIC_SPI 200 IRQ_TYPE_LEVEL_HIGH>,
> + <GIC_SPI 218 IRQ_TYPE_LEVEL_HIGH>,
> + <GIC_SPI 219 IRQ_TYPE_LEVEL_HIGH>,
> + <GIC_SPI 121 IRQ_TYPE_LEVEL_HIGH>;
> + interrupt-names = "msi0",
> + "msi1",
> + "msi2",
> + "msi3",
> + "msi4",
> + "msi5",
> + "msi6",
> + "msi7",
> + "global";
> +
> + #interrupt-cells = <1>;
> + interrupt-map-mask = <0 0 0 0x7>;
> + interrupt-map = <0 0 0 1 &intc 0 0 GIC_SPI 220 IRQ_TYPE_LEVEL_HIGH>,
> + <0 0 0 2 &intc 0 0 GIC_SPI 221 IRQ_TYPE_LEVEL_HIGH>,
> + <0 0 0 3 &intc 0 0 GIC_SPI 237 IRQ_TYPE_LEVEL_HIGH>,
> + <0 0 0 4 &intc 0 0 GIC_SPI 238 IRQ_TYPE_LEVEL_HIGH>;
> +
> + clocks = <&gcc GCC_PCIE_3_AUX_CLK>,
> + <&gcc GCC_PCIE_3_CFG_AHB_CLK>,
> + <&gcc GCC_PCIE_3_MSTR_AXI_CLK>,
> + <&gcc GCC_PCIE_3_SLV_AXI_CLK>,
> + <&gcc GCC_PCIE_3_SLV_Q2A_AXI_CLK>,
> + <&gcc GCC_CFG_NOC_PCIE_ANOC_NORTH_AHB_CLK>,
> + <&gcc GCC_CNOC_PCIE_NORTH_SF_AXI_CLK>;
> + clock-names = "aux",
> + "cfg",
> + "bus_master",
> + "bus_slave",
> + "slave_q2a",
> + "noc_aggr",
> + "cnoc_sf_axi";
> +
> + assigned-clocks = <&gcc GCC_PCIE_3_AUX_CLK>;
> + assigned-clock-rates = <19200000>;
> +
> + interconnects = <&pcie_south_anoc MASTER_PCIE_3 QCOM_ICC_TAG_ALWAYS
> + &mc_virt SLAVE_EBI1 QCOM_ICC_TAG_ALWAYS>,
> + <&gem_noc MASTER_APPSS_PROC QCOM_ICC_TAG_ALWAYS
> + &cnoc_main SLAVE_PCIE_3 QCOM_ICC_TAG_ALWAYS>;
> + interconnect-names = "pcie-mem",
> + "cpu-pcie";
> +
> + resets = <&gcc GCC_PCIE_3_BCR>,
> + <&gcc GCC_PCIE_3_LINK_DOWN_BCR>;
> + reset-names = "pci",
> + "link_down";
> +
> + power-domains = <&gcc GCC_PCIE_3_GDSC>;
> +
> + phys = <&pcie3_phy>;
> + phy-names = "pciephy";
> +
> + operating-points-v2 = <&pcie3_opp_table>;
> +
> + status = "disabled";
> +
> + pcie3_opp_table: opp-table {
> + compatible = "operating-points-v2";
> +
> + /* GEN 1 x1 */
> + opp-2500000 {
> + opp-hz = /bits/ 64 <2500000>;
> + required-opps = <&rpmhpd_opp_low_svs>;
> + opp-peak-kBps = <250000 1>;
> + };
> +
> + /* GEN 1 x2 and GEN 2 x1 */
> + opp-5000000 {
> + opp-hz = /bits/ 64 <5000000>;
> + required-opps = <&rpmhpd_opp_low_svs>;
> + opp-peak-kBps = <500000 1>;
> + };
> +
> + /* GEN 1 x4 and GEN 2 x2 */
> + opp-10000000 {
> + opp-hz = /bits/ 64 <10000000>;
> + required-opps = <&rpmhpd_opp_low_svs>;
> + opp-peak-kBps = <1000000 1>;
> + };
> +
> + /* GEN 1 x8 and GEN 2 x4 */
> + opp-20000000 {
> + opp-hz = /bits/ 64 <20000000>;
> + required-opps = <&rpmhpd_opp_low_svs>;
> + opp-peak-kBps = <2000000 1>;
> + };
> +
> + /* GEN 2 x8 */
> + opp-40000000 {
> + opp-hz = /bits/ 64 <40000000>;
> + required-opps = <&rpmhpd_opp_low_svs>;
> + opp-peak-kBps = <4000000 1>;
> + };
> +
> + /* GEN 3 x1 */
> + opp-8000000 {
> + opp-hz = /bits/ 64 <8000000>;
> + required-opps = <&rpmhpd_opp_svs>;
> + opp-peak-kBps = <984500 1>;
> + };
> +
> + /* GEN 3 x2 and GEN 4 x1 */
> + opp-16000000 {
> + opp-hz = /bits/ 64 <16000000>;
> + required-opps = <&rpmhpd_opp_svs>;
> + opp-peak-kBps = <1969000 1>;
> + };
> +
> + /* GEN 3 x4 and GEN 4 x2 */
> + opp-32000000 {
> + opp-hz = /bits/ 64 <32000000>;
> + required-opps = <&rpmhpd_opp_svs>;
> + opp-peak-kBps = <3938000 1>;
> + };
> +
> + /* GEN 3 x8 and GEN 4 x4 */
> + opp-64000000 {
> + opp-hz = /bits/ 64 <64000000>;
> + required-opps = <&rpmhpd_opp_svs>;
> + opp-peak-kBps = <7876000 1>;
> + };
> +
> + /* GEN 4 x8 */
> + opp-128000000 {
> + opp-hz = /bits/ 64 <128000000>;
> + required-opps = <&rpmhpd_opp_svs>;
> + opp-peak-kBps = <15753000 1>;
> + };
> + };
> + };
> +
> + pcie3_phy: phy at 1be0000 {
> + compatible = "qcom,x1e80100-qmp-gen4x8-pcie-phy";
> + reg = <0 0x01be0000 0 0x10000>;
> +
> + clocks = <&gcc GCC_PCIE_3_PHY_AUX_CLK>,
> + <&gcc GCC_PCIE_3_CFG_AHB_CLK>,
> + <&tcsr TCSR_PCIE_8L_CLKREF_EN>,
> + <&gcc GCC_PCIE_3_PHY_RCHNG_CLK>,
> + <&gcc GCC_PCIE_3_PIPE_CLK>,
> + <&gcc GCC_PCIE_3_PIPEDIV2_CLK>;
> + clock-names = "aux",
> + "cfg_ahb",
> + "ref",
> + "rchng",
> + "pipe",
> + "pipediv2";
> +
> + resets = <&gcc GCC_PCIE_3_PHY_BCR>,
> + <&gcc GCC_PCIE_3_NOCSR_COM_PHY_BCR>;
> + reset-names = "phy",
> + "phy_nocsr";
> +
> + assigned-clocks = <&gcc GCC_PCIE_3_PHY_RCHNG_CLK>;
> + assigned-clock-rates = <100000000>;
> +
> + power-domains = <&gcc GCC_PCIE_3_PHY_GDSC>;
> +
> + #clock-cells = <0>;
> + clock-output-names = "pcie3_pipe_clk";
> +
> + #phy-cells = <0>;
> +
> + status = "disabled";
> + };
> +
> pcie6a: pci at 1bf8000 {
> device_type = "pci";
> compatible = "qcom,pcie-x1e80100";
> --
> 2.34.1
>
--
மணிவண்ணன் சதாசிவம்
More information about the linux-phy
mailing list