[PATCH 10/16] phy: renesas: rcar-gen3-usb2: Add support to initialize the bus

[Vinod Koul]

On 23-08-24, 09:01, Biju Das wrote:
> > >> The Renesas RZ/G3S need to initialize the USB BUS before transferring data due to hardware
> > limitation.
> > >> As the register that need to be touched for this is in the address
> > >> space of the USB PHY, and the UBS PHY need to be initialized before
> > >> any other USB drivers handling data transfer, add support to initialize the USB BUS.
> > >>
> > >> As the USB PHY is probed before any other USB drivers that enables
> > >> clocks and de-assert the reset signals and the BUS initialization is
> > >> done in the probe phase, we need to add code to de-assert reset signal and runtime resume the
> > device (which enables its clocks) before accessing the registers.
> > >>
> > >> As the reset signals are not required by the USB PHY driver for the
> > >> other USB PHY hardware variants, the reset signals and runtime PM was handled only in the function
> > that initialize the USB BUS.
> > >>
> > >> The PHY initialization was done right after runtime PM enable to have
> > >> all in place when the PHYs are registered.
> > >
> > > There is no user for this patch. The first user is RZ/G3S and you
> > > should merge this patch with next one.
> > 
> > I think this is a matter of taste... This is how I usually format the patches (for scenarios like
> > this) and got no request for squashing.
> 
> That is strange for trivial patches like this.

Splitting is better, this patch does one thing whereas the next one uses
it adds in new device, i would say quite a clean approach

NOTE: Don't quote the not required context while replying, it is good
mail list hygiene

-- 
~Vinod