[PATCH 08/16] reset: rzg2l-usbphy-ctrl: Add support for RZ/G3S
claudiu beznea
claudiu.beznea at tuxon.dev
Fri Aug 23 01:40:37 PDT 2024
Hi, Biju,
On 22.08.2024 19:59, Biju Das wrote:
> Hi Claudiu,
>
>> -----Original Message-----
>> From: Claudiu <claudiu.beznea at tuxon.dev>
>> Sent: Thursday, August 22, 2024 4:28 PM
>> Subject: [PATCH 08/16] reset: rzg2l-usbphy-ctrl: Add support for RZ/G3S
>>
>> From: Claudiu Beznea <claudiu.beznea.uj at bp.renesas.com>
>>
>> Add support for RZ/G3S SoC. It needs its own compatible as it uses 2 reset signals and it cannot work
>> w/o both of them. To be able to fully validate this on DT schema, too, the RZ/G3S uses it's own
>> compatible w/o a fallback (as if the fallback will be used the RZ/G3S will not work anyway).
>
> Other than reset/ power domain approach for handling USBPWRRDY signal
>
> Can't USBPWRRDY signal handled in SYSC driver directly? Since SYSC driver init happens at very early boot stage
> Check for USBPHY control device availability and handle USBPWRRDY signal there??
In theory, it can be done this way, too. The downside I see at the moment
with this approach would be that the USB, PCIe drivers will not be in
charge with handling their signals, there will be no direct dependency
available b/w SYSC and USB drivers.
The HW manual doesn't mention anything about the power consumption of the
USB, PCI areas based on the state of the signals from SYSC, so, I don't
know if there will be any implication on this if the signals will be just
de-asserted from the SYSC driver.
Thank you,
Claudiu Beznea
> Cheers,
> Biju
>
>>
>> Signed-off-by: Claudiu Beznea <claudiu.beznea.uj at bp.renesas.com>
>> ---
>> drivers/reset/reset-rzg2l-usbphy-ctrl.c | 1 +
>> 1 file changed, 1 insertion(+)
>>
>> diff --git a/drivers/reset/reset-rzg2l-usbphy-ctrl.c b/drivers/reset/reset-rzg2l-usbphy-ctrl.c
>> index 8b64c12f3bec..08b18d7de7ad 100644
>> --- a/drivers/reset/reset-rzg2l-usbphy-ctrl.c
>> +++ b/drivers/reset/reset-rzg2l-usbphy-ctrl.c
>> @@ -93,6 +93,7 @@ static int rzg2l_usbphy_ctrl_status(struct reset_controller_dev *rcdev,
>>
>> static const struct of_device_id rzg2l_usbphy_ctrl_match_table[] = {
>> { .compatible = "renesas,rzg2l-usbphy-ctrl" },
>> + { .compatible = "renesas,r9a08g045-usbphy-ctrl" },
>> { /* Sentinel */ }
>> };
>> MODULE_DEVICE_TABLE(of, rzg2l_usbphy_ctrl_match_table);
>> --
>> 2.39.2
>
More information about the linux-phy
mailing list