[PATCH] phy: phy-rockchip-inno-usb2: Handle failed extcon allocation better

[Dragan Simic]

Hello Heiko,

On 2024-08-15 18:12, Heiko Stübner wrote:
> Am Dienstag, 13. August 2024, 20:38:17 CEST schrieb Dragan Simic:
>> Return the actual error code upon failure to allocate extcon device, 
>> instead
>> of hardcoding -ENOMEM.  While there, produce an appropriate error 
>> message.
>> 
>> Signed-off-by: Dragan Simic <dsimic at manjaro.org>
>> ---
>>  drivers/phy/rockchip/phy-rockchip-inno-usb2.c | 6 ++++--
>>  1 file changed, 4 insertions(+), 2 deletions(-)
>> 
>> diff --git a/drivers/phy/rockchip/phy-rockchip-inno-usb2.c 
>> b/drivers/phy/rockchip/phy-rockchip-inno-usb2.c
>> index 4f71373ae6e1..d33418a1e7a8 100644
>> --- a/drivers/phy/rockchip/phy-rockchip-inno-usb2.c
>> +++ b/drivers/phy/rockchip/phy-rockchip-inno-usb2.c
>> @@ -434,8 +434,10 @@ static int 
>> rockchip_usb2phy_extcon_register(struct rockchip_usb2phy *rphy)
>>  		edev = devm_extcon_dev_allocate(rphy->dev,
>>  						rockchip_usb2phy_extcon_cable);
>> 
>> -		if (IS_ERR(edev))
>> -			return -ENOMEM;
>> +		if (IS_ERR(edev)) {
>> +			dev_err(rphy->dev, "failed to allocate extcon device\n");
>> +			return PTR_ERR(edev);
>> +		}
> 
> maybe even use dev_err_probe?
> 
> rockchip_usb2phy_extcon_register() gets called from the probe function,
> so even using it is also sematically correct ;-) .

Good suggestion, thanks!  I'll use dev_err_probe() in the v2, albeit it
also calls for turning this into a small patch series that additionally
replaces dev_err() with dev_err_probe() in the rockchip_usb2phy_probe()
function, for consistency. :)

>>  		ret = devm_extcon_dev_register(rphy->dev, edev);
>>  		if (ret) {
>>