[PATCH 2/5] dt-bindings: phy: Add STM32MP25 COMBOPHY bindings

[Rob Herring (Arm)]

On Mon, 12 Aug 2024 14:05:26 +0200, Christian Bruel wrote:
> Document the bindings for STM32 COMBOPHY interface, used to support
> the PCIe and USB3 stm32mp25 drivers.
> Following entries can be used to tune caracterisation parameters
>  - st,output-micro-ohms and st,output-vswing-microvolt bindings entries
> to tune the impedance and voltage swing using discrete simulation results
>  - st, phy_rx0_eq register to set the internal rx equalizer filter value.
> 
> Signed-off-by: Christian Bruel <christian.bruel at foss.st.com>
> ---
>  .../bindings/phy/st,stm32-combophy.yaml       | 178 ++++++++++++++++++
>  1 file changed, 178 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/phy/st,stm32-combophy.yaml
> 

My bot found errors running 'make dt_binding_check' on your patch:

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/phy/st,stm32-combophy.yaml: access-controllers: missing type definition

doc reference errors (make refcheckdocs):

See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20240812120529.3564390-3-christian.bruel@foss.st.com

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.