[PATCH v2 2/2] phy: nuvoton: add new driver for the Nuvoton MA35 SoC USB 2.0 PHY

[Krzysztof Kozlowski]

On 31/07/2024 03:43, Hui-Ping Chen wrote:
> Nuvoton MA35 SoCs support DWC2 USB controller.
> Add the driver to drive the USB 2.0 PHY transceivers.
> 
> Signed-off-by: Hui-Ping Chen <hpchen0nvt at gmail.com>


> +struct ma35_usb_phy {
> +	struct clk *clk;
> +	struct device *dev;
> +	struct regmap *sysreg;
> +};
> +
> +static int ma35_usb_phy_power_on(struct phy *phy)
> +{
> +	struct ma35_usb_phy *p_phy = phy_get_drvdata(phy);
> +	unsigned int val;
> +	int ret;
> +
> +	ret = clk_prepare_enable(p_phy->clk);
> +	if (ret < 0) {
> +		dev_err(p_phy->dev, "Failed to enable PHY clock: %d\n", ret);
> +		return ret;
> +	}
> +
> +	regmap_read(p_phy->sysreg, MA35_SYS_REG_USBPMISCR, &val);
> +	if (val & PHY0SUSPEND) {
> +		/*
> +		 * USB PHY0 is in operation mode already
> +		 * make sure USB PHY 60 MHz UTMI Interface Clock ready
> +		 */
> +		ret = readl_poll_timeout((void __iomem *)p_phy->sysreg + MA35_SYS_REG_USBPMISCR,

sysreg is a regmap, not io address. How could it possibly work and be
tested?!? This cannot work. Test your code *before* sending it.

> +					 val, val & PHY0DEVCKSTB, 1, 100);
> +		if (ret == -ETIMEDOUT) {
> +			dev_err(p_phy->dev, "1.Check PHY clock, Timeout: %d\n", val);
> +			return ret;
> +		}
> +		return 0;
> +	}
> +
> +	/*
> +	 * reset USB PHY0.
> +	 * wait until USB PHY0 60 MHz UTMI Interface Clock ready
> +	 */
> +	regmap_update_bits(p_phy->sysreg, MA35_SYS_REG_USBPMISCR, 0x7, (PHY0POR | PHY0SUSPEND));
> +	udelay(10);
> +
> +	/* make USB PHY0 enter operation mode */
> +	regmap_update_bits(p_phy->sysreg, MA35_SYS_REG_USBPMISCR, 0x7, PHY0SUSPEND);
> +
> +	/* make sure USB PHY 60 MHz UTMI Interface Clock ready */
> +	ret = readl_poll_timeout((void __iomem *)p_phy->sysreg + MA35_SYS_REG_USBPMISCR,

Same problem.


Best regards,
Krzysztof