[PATCH 3/6] phy: qcom: Introduce PCIe UNIPHY 28LP driver

[Krzysztof Kozlowski]

On 03/10/2023 14:08, Nitheesh Sekar wrote:
> Add Qualcomm PCIe UNIPHY 28LP driver support present
> in Qualcomm IPQ5018 SoC and the phy init sequence.
> 
> Signed-off-by: Nitheesh Sekar <quic_nsekar at quicinc.com>
> ---

...

> +static int qcom_uniphy_pcie_probe(struct platform_device *pdev)
> +{
> +	struct qcom_uniphy_pcie *phy;
> +	int ret;
> +	struct phy *generic_phy;
> +	struct phy_provider *phy_provider;
> +	struct device *dev = &pdev->dev;
> +	struct device_node *np = of_node_get(dev->of_node);
> +
> +	phy = devm_kzalloc(&pdev->dev, sizeof(*phy), GFP_KERNEL);
> +	if (!phy)
> +		return -ENOMEM;
> +
> +	platform_set_drvdata(pdev, phy);
> +	phy->dev = &pdev->dev;
> +
> +	phy->data = of_device_get_match_data(dev);
> +	if (!phy->data)
> +		return -EINVAL;
> +
> +	ret = qcom_uniphy_pcie_get_resources(pdev, phy);
> +	if (ret < 0) {
> +		dev_err(&pdev->dev, "failed to get resources: %d\n", ret);
> +		return ret;

Syntax is:
return dev_err_probe()


> +	}
> +
> +	ret = phy_pipe_clk_register(phy, np);
> +	if (ret)
> +		dev_err(&pdev->dev, "failed to register phy pipe clk\n");
> +
> +	generic_phy = devm_phy_create(phy->dev, NULL, &pcie_ops);
> +	if (IS_ERR(generic_phy))
> +		return PTR_ERR(generic_phy);
> +
> +	phy_set_drvdata(generic_phy, phy);
> +	phy_provider = devm_of_phy_provider_register(phy->dev,
> +						     of_phy_simple_xlate);
> +	if (IS_ERR(phy_provider))
> +		return PTR_ERR(phy_provider);
> +
> +	return 0;
> +}
> +
> +static struct platform_driver qcom_uniphy_pcie_driver = {
> +	.probe		= qcom_uniphy_pcie_probe,
> +	.driver		= {
> +		.name	= "qcom-uniphy-pcie",
> +		.owner	= THIS_MODULE,

Run coccinelle/coccicheck.

> +		.of_match_table = qcom_uniphy_pcie_id_table,
> +	},
> +};
> +
> +module_platform_driver(qcom_uniphy_pcie_driver);
> +
> +MODULE_ALIAS("platform:qcom-uniphy-pcie");

You should not need MODULE_ALIAS() in normal cases. If you need it,
usually it means your device ID table is wrong.


Best regards,
Krzysztof