[PATCH] phy: hisilicon: Adopt phy-hisi-inno-usb2 to Hi3798MV100

[Vinod Koul]

On 07-05-23, 23:46, David Yang wrote:
> Hisilicon also uses phy-hisi-inno-usb2 on Hi3798MV100, with a slightly
> different register convention.

OK, so what should I expect from this patch, pls document that here...

> 
> Signed-off-by: David Yang <mmyangfl at gmail.com>
> ---
>  drivers/phy/hisilicon/Kconfig              |  2 +-
>  drivers/phy/hisilicon/phy-hisi-inno-usb2.c | 67 ++++++++++++++++------
>  2 files changed, 51 insertions(+), 18 deletions(-)
> 
> diff --git a/drivers/phy/hisilicon/Kconfig b/drivers/phy/hisilicon/Kconfig
> index d3b92c288554..6c89136fc8c2 100644
> --- a/drivers/phy/hisilicon/Kconfig
> +++ b/drivers/phy/hisilicon/Kconfig
> @@ -54,7 +54,7 @@ config PHY_HISTB_COMBPHY
>  
>  config PHY_HISI_INNO_USB2
>  	tristate "HiSilicon INNO USB2 PHY support"
> -	depends on (ARCH_HISI && ARM64) || COMPILE_TEST
> +	depends on ARCH_HISI || COMPILE_TEST

why this change?

>  	select GENERIC_PHY
>  	select MFD_SYSCON
>  	help
> diff --git a/drivers/phy/hisilicon/phy-hisi-inno-usb2.c b/drivers/phy/hisilicon/phy-hisi-inno-usb2.c
> index b133ae06757a..b5d006f38934 100644
> --- a/drivers/phy/hisilicon/phy-hisi-inno-usb2.c
> +++ b/drivers/phy/hisilicon/phy-hisi-inno-usb2.c
> @@ -9,7 +9,7 @@
>  #include <linux/delay.h>
>  #include <linux/io.h>
>  #include <linux/module.h>
> -#include <linux/platform_device.h>
> +#include <linux/of_device.h>
>  #include <linux/phy/phy.h>
>  #include <linux/reset.h>
>  
> @@ -20,12 +20,28 @@
>  #define PHY_CLK_STABLE_TIME	2	/* unit:ms */
>  #define UTMI_RST_COMPLETE_TIME	2	/* unit:ms */
>  #define POR_RST_COMPLETE_TIME	300	/* unit:us */
> -#define PHY_TEST_DATA		GENMASK(7, 0)
> -#define PHY_TEST_ADDR		GENMASK(15, 8)
> -#define PHY_TEST_PORT		GENMASK(18, 16)
> -#define PHY_TEST_WREN		BIT(21)
> -#define PHY_TEST_CLK		BIT(22)	/* rising edge active */
> -#define PHY_TEST_RST		BIT(23)	/* low active */
> +
> +#define PHY_TYPE_0	0
> +#define PHY_TYPE_1	1
> +
> +#define PHY0_TEST_DATA		GENMASK(7, 0)

same as previous what changed??

> +#define PHY0_TEST_ADDR_OFFSET	8
> +#define PHY0_TEST_ADDR		GENMASK(15, 8)
> +#define PHY0_TEST_PORT_OFFSET	16
> +#define PHY0_TEST_PORT		GENMASK(18, 16)
> +#define PHY0_TEST_WREN		BIT(21)
> +#define PHY0_TEST_CLK		BIT(22)	/* rising edge active */
> +#define PHY0_TEST_RST		BIT(23)	/* low active */
> +
> +#define PHY1_TEST_DATA		GENMASK(7, 0)
> +#define PHY1_TEST_ADDR_OFFSET	8
> +#define PHY1_TEST_ADDR		GENMASK(11, 8)
> +#define PHY1_TEST_PORT_OFFSET	12
> +#define PHY1_TEST_PORT		BIT(12)
> +#define PHY1_TEST_WREN		BIT(13)
> +#define PHY1_TEST_CLK		BIT(14)	/* rising edge active */
> +#define PHY1_TEST_RST		BIT(15)	/* low active */
> +
>  #define PHY_CLK_ENABLE		BIT(2)
>  
>  struct hisi_inno_phy_port {
> @@ -37,6 +53,7 @@ struct hisi_inno_phy_priv {
>  	void __iomem *mmio;
>  	struct clk *ref_clk;
>  	struct reset_control *por_rst;
> +	unsigned int type;
>  	struct hisi_inno_phy_port ports[INNO_PHY_PORT_NUM];
>  };
>  
> @@ -45,17 +62,27 @@ static void hisi_inno_phy_write_reg(struct hisi_inno_phy_priv *priv,
>  {
>  	void __iomem *reg = priv->mmio;
>  	u32 val;
> -
> -	val = (data & PHY_TEST_DATA) |
> -	      ((addr << 8) & PHY_TEST_ADDR) |
> -	      ((port << 16) & PHY_TEST_PORT) |
> -	      PHY_TEST_WREN | PHY_TEST_RST;
> +	u32 value;
> +
> +	if (priv->type == PHY_TYPE_0)
> +		val = (data & PHY0_TEST_DATA) |
> +		      ((addr << PHY0_TEST_ADDR_OFFSET) & PHY0_TEST_ADDR) |
> +		      ((port << PHY0_TEST_PORT_OFFSET) & PHY0_TEST_PORT) |
> +		      PHY0_TEST_WREN | PHY0_TEST_RST;
> +	else
> +		val = (data & PHY1_TEST_DATA) |
> +		      ((addr << PHY1_TEST_ADDR_OFFSET) & PHY1_TEST_ADDR) |
> +		      ((port << PHY1_TEST_PORT_OFFSET) & PHY1_TEST_PORT) |
> +		      PHY1_TEST_WREN | PHY1_TEST_RST;
>  	writel(val, reg);
>  
> -	val |= PHY_TEST_CLK;
> -	writel(val, reg);
> +	value = val;
> +	if (priv->type == PHY_TYPE_0)
> +		value |= PHY0_TEST_CLK;
> +	else
> +		value |= PHY1_TEST_CLK;
> +	writel(value, reg);
>  
> -	val &= ~PHY_TEST_CLK;
>  	writel(val, reg);
>  }
>  
> @@ -135,6 +162,8 @@ static int hisi_inno_phy_probe(struct platform_device *pdev)
>  	if (IS_ERR(priv->por_rst))
>  		return PTR_ERR(priv->por_rst);
>  
> +	priv->type = (unsigned int) of_device_get_match_data(dev);
> +
>  	for_each_child_of_node(np, child) {
>  		struct reset_control *rst;
>  		struct phy *phy;
> @@ -170,8 +199,12 @@ static int hisi_inno_phy_probe(struct platform_device *pdev)
>  }
>  
>  static const struct of_device_id hisi_inno_phy_of_match[] = {
> -	{ .compatible = "hisilicon,inno-usb2-phy", },
> -	{ .compatible = "hisilicon,hi3798cv200-usb2-phy", },
> +	{ .compatible = "hisilicon,inno-usb2-phy",
> +	  .data = (void *) PHY_TYPE_0 },
> +	{ .compatible = "hisilicon,hi3798cv200-usb2-phy",
> +	  .data = (void *) PHY_TYPE_0 },
> +	{ .compatible = "hisilicon,hi3798mv100-usb2-phy",
> +	  .data = (void *) PHY_TYPE_1 },
>  	{ },
>  };
>  MODULE_DEVICE_TABLE(of, hisi_inno_phy_of_match);
> -- 
> 2.39.2

-- 
~Vinod