[PATCH v7 7/8] arm64: dts: qcom: ipq9574: Add USB related nodes

[Johan Hovold]

On Wed, Apr 05, 2023 at 03:24:04PM +0530, Varadarajan Narayanan wrote:
> Add USB phy and controller related nodes
> 
> Signed-off-by: Varadarajan Narayanan <quic_varada at quicinc.com>
> ---
>  Changes in v7:
> 	- Change com_aux -> cfg_ahb
>  Changes in v6:
> 	- Introduce fixed regulators for the phy
> 	- Resolved all 'make dtbs_check' messages

> +		usb_0_qmpphy: phy at 7d000 {
> +			compatible = "qcom,ipq9574-qmp-usb3-phy";
> +			reg = <0x0007d000 0xa00>;
> +			#phy-cells = <0>;
> +
> +			clocks = <&gcc GCC_USB0_AUX_CLK>,
> +				 <&xo_board_clk>,
> +				 <&gcc GCC_USB0_PHY_CFG_AHB_CLK>,
> +				 <&gcc GCC_USB0_PIPE_CLK>;
> +			clock-names = "aux",
> +				      "ref",
> +				      "cfg_ahb",

You still did not update the binding to match this clock. So this is
essentially the third time I'm pointing out the same issue. This is
simply not acceptable.

Just slow down, and don't rush out new revisions of series before
you've had time to review them yourself (and preferably internally at
qualcomm) to make sure that you have addressed all review comments you
have received.

Maintainer and reviewer time is scarce. Our development model really
does not scale unless people take more care.

Johan