[PATCH 10/15] scsi: ufs: ufs-qcom: Use bitfields where appropriate

[Manivannan Sadhasivam]

On Sun, Oct 30, 2022 at 12:58:57AM +0300, Dmitry Baryshkov wrote:
> On 29/10/2022 17:16, Manivannan Sadhasivam wrote:
> > Use bitfield macros where appropriate to simplify the driver.
> > 
> > Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam at linaro.org>
> > ---
> >   drivers/ufs/host/ufs-qcom.h | 58 ++++++++++++++++---------------------
> >   1 file changed, 25 insertions(+), 33 deletions(-)
> > 
> 
> Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
> 
> > diff --git a/drivers/ufs/host/ufs-qcom.h b/drivers/ufs/host/ufs-qcom.h
> > index 44466a395bb5..6cb0776456b3 100644
> > --- a/drivers/ufs/host/ufs-qcom.h
> > +++ b/drivers/ufs/host/ufs-qcom.h
> > @@ -17,12 +17,9 @@
> >   #define DEFAULT_CLK_RATE_HZ     1000000
> >   #define BUS_VECTOR_NAME_LEN     32
> > -#define UFS_HW_VER_MAJOR_SHFT	(28)
> > -#define UFS_HW_VER_MAJOR_MASK	(0x000F << UFS_HW_VER_MAJOR_SHFT)
> > -#define UFS_HW_VER_MINOR_SHFT	(16)
> > -#define UFS_HW_VER_MINOR_MASK	(0x0FFF << UFS_HW_VER_MINOR_SHFT)
> > -#define UFS_HW_VER_STEP_SHFT	(0)
> > -#define UFS_HW_VER_STEP_MASK	(0xFFFF << UFS_HW_VER_STEP_SHFT)
> > +#define UFS_HW_VER_MAJOR_MASK	GENMASK(31, 28)
> > +#define UFS_HW_VER_MINOR_MASK	GENMASK(27, 16)
> > +#define UFS_HW_VER_STEP_MASK	GENMASK(15, 0)
> >   /* vendor specific pre-defined parameters */
> >   #define SLOW 1
> > @@ -76,24 +73,24 @@ enum {
> >   #define UFS_CNTLR_3_x_x_VEN_REGS_OFFSET(x)	(0x400 + x)
> >   /* bit definitions for REG_UFS_CFG1 register */
> > -#define QUNIPRO_SEL		0x1
> > -#define UTP_DBG_RAMS_EN		0x20000
> > +#define QUNIPRO_SEL		BIT(0)
> > +#define UTP_DBG_RAMS_EN		BIT(17)
> >   #define TEST_BUS_EN		BIT(18)
> >   #define TEST_BUS_SEL		GENMASK(22, 19)
> >   #define UFS_REG_TEST_BUS_EN	BIT(30)
> >   /* bit definitions for REG_UFS_CFG2 register */
> > -#define UAWM_HW_CGC_EN		(1 << 0)
> > -#define UARM_HW_CGC_EN		(1 << 1)
> > -#define TXUC_HW_CGC_EN		(1 << 2)
> > -#define RXUC_HW_CGC_EN		(1 << 3)
> > -#define DFC_HW_CGC_EN		(1 << 4)
> > -#define TRLUT_HW_CGC_EN		(1 << 5)
> > -#define TMRLUT_HW_CGC_EN	(1 << 6)
> > -#define OCSC_HW_CGC_EN		(1 << 7)
> > +#define UAWM_HW_CGC_EN		BIT(0)
> > +#define UARM_HW_CGC_EN		BIT(1)
> > +#define TXUC_HW_CGC_EN		BIT(2)
> > +#define RXUC_HW_CGC_EN		BIT(3)
> > +#define DFC_HW_CGC_EN		BIT(4)
> > +#define TRLUT_HW_CGC_EN		BIT(5)
> > +#define TMRLUT_HW_CGC_EN	BIT(6)
> > +#define OCSC_HW_CGC_EN		BIT(7)
> >   /* bit definition for UFS_UFS_TEST_BUS_CTRL_n */
> > -#define TEST_BUS_SUB_SEL_MASK	0x1F  /* All XXX_SEL fields are 5 bits wide */
> > +#define TEST_BUS_SUB_SEL_MASK	GENMASK(4, 0)  /* All XXX_SEL fields are 5 bits wide */
> >   #define REG_UFS_CFG2_CGC_EN_ALL (UAWM_HW_CGC_EN | UARM_HW_CGC_EN |\
> >   				 TXUC_HW_CGC_EN | RXUC_HW_CGC_EN |\
> > @@ -101,17 +98,12 @@ enum {
> >   				 TMRLUT_HW_CGC_EN | OCSC_HW_CGC_EN)
> >   /* bit offset */
> > -enum {
> > -	OFFSET_UFS_PHY_SOFT_RESET           = 1,
> > -	OFFSET_CLK_NS_REG                   = 10,
> > -};
> > +#define OFFSET_CLK_NS_REG		0xa
> >   /* bit masks */
> > -enum {
> > -	MASK_UFS_PHY_SOFT_RESET             = 0x2,
> > -	MASK_TX_SYMBOL_CLK_1US_REG          = 0x3FF,
> > -	MASK_CLK_NS_REG                     = 0xFFFC00,
> > -};
> > +#define MASK_UFS_PHY_SOFT_RESET		BIT(1)
> > +#define MASK_TX_SYMBOL_CLK_1US_REG	GENMASK(9, 0)
> > +#define MASK_CLK_NS_REG			GENMASK(23, 10)
> >   /* QCOM UFS debug print bit mask */
> >   #define UFS_QCOM_DBG_PRINT_REGS_EN	BIT(0)
> > @@ -135,15 +127,15 @@ ufs_qcom_get_controller_revision(struct ufs_hba *hba,
> >   {
> >   	u32 ver = ufshcd_readl(hba, REG_UFS_HW_VERSION);
> > -	*major = (ver & UFS_HW_VER_MAJOR_MASK) >> UFS_HW_VER_MAJOR_SHFT;
> > -	*minor = (ver & UFS_HW_VER_MINOR_MASK) >> UFS_HW_VER_MINOR_SHFT;
> > -	*step = (ver & UFS_HW_VER_STEP_MASK) >> UFS_HW_VER_STEP_SHFT;
> > +	*major = FIELD_GET(UFS_HW_VER_MAJOR_MASK, ver);
> > +	*minor = FIELD_GET(UFS_HW_VER_MINOR_MASK, ver);
> > +	*step = FIELD_GET(UFS_HW_VER_STEP_MASK, ver);
> >   };
> >   static inline void ufs_qcom_assert_reset(struct ufs_hba *hba)
> >   {
> > -	ufshcd_rmwl(hba, MASK_UFS_PHY_SOFT_RESET,
> > -			1 << OFFSET_UFS_PHY_SOFT_RESET, REG_UFS_CFG1);
> > +	ufshcd_rmwl(hba, MASK_UFS_PHY_SOFT_RESET, FIELD_PREP(MASK_UFS_PHY_SOFT_RESET, 1),
> 
> Nit: I'd just define the value too and use the defined name here.
> 
> > +		    REG_UFS_CFG1);
> >   	/*
> >   	 * Make sure assertion of ufs phy reset is written to
> > @@ -154,8 +146,8 @@ static inline void ufs_qcom_assert_reset(struct ufs_hba *hba)
> >   static inline void ufs_qcom_deassert_reset(struct ufs_hba *hba)
> >   {
> > -	ufshcd_rmwl(hba, MASK_UFS_PHY_SOFT_RESET,
> > -			0 << OFFSET_UFS_PHY_SOFT_RESET, REG_UFS_CFG1);
> > +	ufshcd_rmwl(hba, MASK_UFS_PHY_SOFT_RESET, FIELD_PREP(MASK_UFS_PHY_SOFT_RESET, 0),
> 
> Nit: FIELD_PREP is always 0.
> 

I know but this make the code in sync with reset assert.

Thanks,
Mani

> > +		    REG_UFS_CFG1);
> >   	/*
> >   	 * Make sure de-assertion of ufs phy reset is written to
> 
> -- 
> With best wishes
> Dmitry
> 

-- 
மணிவண்ணன் சதாசிவம்