[PATCH v2 0/6] PCI: qcom: Support using the same PHY for both RC and EP

[Dmitry Baryshkov]

Programming of QMP PCIe PHYs slightly differs between RC and EP modes.

Currently both qcom and qcom-ep PCIe controllers setup the PHY in the
default mode, making it impossible to select at runtime whether the PHY
should be running in RC or in EP modes. Usually this is not an issue,
since for most devices only the RC mode is used. Some devices (SDX55)
currently support only the EP mode without supporting the RC mode (at
this moment).

Nevertheless some of the Qualcomm platforms (e.g. the aforementioned
SDX55) would still benefit from being able to switch between RC and EP
depending on the driver being used. While it is possible to use
different compat strings for the PHY depending on the mode, it seems
like an incorrect approach, since the PHY doesn't differ between
usecases. It's the PCIe controller, who should decide how to configure
the PHY.

This patch series implements the ability to select between RC and EP
modes, by allowing the PCIe QMP PHY driver to switch between
programming tables.

Note, there is no direct dependency between PCIe and PHY parts of these
series, so these patches can be merged into respective subsystem trees
separately.

Changes since v1:
- Split the if(table) removal to the separate patch
- Expanded commit messages and comments to provide additional details
- Fixed build error on pcie-qcom.c
- Added support for EP mode on sm8450 to demonstrate the usage of this
  patchset

Changes since RFC:
- Fixed the compilation of PCIe EP driver,
- Changed pri/sec names to primary and secondary,
- Added comments regarding usage of secondary_rc/_ep fields.

Dmitry Baryshkov (6):
  phy: qcom-qmp-pcie: drop if (table) conditions
  phy: qcom-qmp-pcie: split register tables into primary and secondary
    part
  phy: qcom-qmp-pcie: support separate tables for EP mode
  PCI: qcom: Setup PHY to work in RC mode
  PCI: qcom-ep: Setup PHY to work in EP mode
  phy: qcom-qmp-pcie: Support SM8450 PCIe1 PHY in EP mode

 drivers/pci/controller/dwc/pcie-qcom-ep.c     |   4 +
 drivers/pci/controller/dwc/pcie-qcom.c        |   4 +
 drivers/phy/qualcomm/phy-qcom-qmp-pcie.c      | 261 ++++++++++++------
 .../qualcomm/phy-qcom-qmp-pcs-pcie-v5_20.h    |   1 +
 4 files changed, 188 insertions(+), 82 deletions(-)

-- 
2.35.1