[PATCH 6/8] phy: allwinner: phy-sun6i-mipi-dphy: Set enable bit last
Samuel Holland
samuel at sholland.org
Fri Aug 12 15:31:54 PDT 2022
Hi Paul,
On 8/12/22 7:03 AM, Paul Kocialkowski wrote:
> On Fri 12 Aug 22, 02:56, Samuel Holland wrote:
>> The A100 variant of the DPHY requires configuring the analog registers
>> before setting the global enable bit. Since this order also works on the
>> other variants, always use it, to minimize the differences between them.
>
> Did you get a chance to actually test this with either DSI/CSI-2 hardware?
I have tested DSI output with the Clockwork DevTerm (D1 SoC) and Pine64
PinePhone (A64 SoC). I do not have any MIPI CSI hardware to test with.
> I vaguely remember that the order mattered. Do you have an idea of what the
> Allwinner BSP does too?
The Allwinner BSP makes the same change as this commit in its "lowlevel_v2x"
copy of the code, which is used for R40 and T7 (original DPHY) and A100 and D1
(updated DPHY). It does not make the change in "lowlevel_sun50iw1" (A64 SoC,
original DPHY), but I tested A64 with this change, and it works fine.
> Otherwise I could give it a try, at least with my MIPI CSI-2 setup
> that uses the driver.
This commit only changes sun6i_dphy_tx_power_on(). The code for RX is unchanged
-- in fact, it already sets SUN6I_DPHY_GCTL_REG last.
Regards,
Samuel
>> Signed-off-by: Samuel Holland <samuel at sholland.org>
>> ---
>>
>> drivers/phy/allwinner/phy-sun6i-mipi-dphy.c | 8 ++++----
>> 1 file changed, 4 insertions(+), 4 deletions(-)
>>
>> diff --git a/drivers/phy/allwinner/phy-sun6i-mipi-dphy.c b/drivers/phy/allwinner/phy-sun6i-mipi-dphy.c
>> index 625c6e1e9990..9698d68d0db7 100644
>> --- a/drivers/phy/allwinner/phy-sun6i-mipi-dphy.c
>> +++ b/drivers/phy/allwinner/phy-sun6i-mipi-dphy.c
>> @@ -183,10 +183,6 @@ static int sun6i_dphy_tx_power_on(struct sun6i_dphy *dphy)
>> SUN6I_DPHY_TX_TIME4_HS_TX_ANA0(3) |
>> SUN6I_DPHY_TX_TIME4_HS_TX_ANA1(3));
>>
>> - regmap_write(dphy->regs, SUN6I_DPHY_GCTL_REG,
>> - SUN6I_DPHY_GCTL_LANE_NUM(dphy->config.lanes) |
>> - SUN6I_DPHY_GCTL_EN);
>> -
>> regmap_write(dphy->regs, SUN6I_DPHY_ANA0_REG,
>> SUN6I_DPHY_ANA0_REG_PWS |
>> SUN6I_DPHY_ANA0_REG_DMPC |
>> @@ -244,6 +240,10 @@ static int sun6i_dphy_tx_power_on(struct sun6i_dphy *dphy)
>> SUN6I_DPHY_ANA2_EN_P2S_CPU_MASK,
>> SUN6I_DPHY_ANA2_EN_P2S_CPU(lanes_mask));
>>
>> + regmap_write(dphy->regs, SUN6I_DPHY_GCTL_REG,
>> + SUN6I_DPHY_GCTL_LANE_NUM(dphy->config.lanes) |
>> + SUN6I_DPHY_GCTL_EN);
>> +
>> return 0;
>> }
>>
>> --
>> 2.35.1
>>
>
More information about the linux-phy
mailing list