[RFC v3] PCMCIA locking updates for 2.6.34

Dominik Brodowski linux at dominikbrodowski.net
Sat Feb 20 16:55:09 EST 2010


Hey,

On Sun, Feb 21, 2010 at 05:19:13AM +0900, Komuro wrote:
> >> eth0: 3Com 3c589, io 0x300, irq 3, hw_addr 00:00:86:xx:xx:xx
> >>   8K FIFO split 5:3 Rx:Tx, auto xcvr
> 
> >Did you modify the hw_addr here, or is it reported wrongly here, compared to
> 
> sorry, I modified the hw_addr, so the hw_addr is same between 2.6.33-rc8
> and the PCMCIA patches.
> 
> > eth8: command 0x5800 did not complete!
> > eth8: command 0x5800 did not complete!
> > eth8: command 0x5800 did not complete!
> > eth8: command 0x5800 did not complete!
> > eth8: command 0x5800 did not complete!
> 
> Actually, this error happens when the conf->ConfigIndex of the 3com card 
> is not set up properly...

but that is statically set to "1" in 3c589_cs.c? I'm a bit confused...

Best,
	Dominik



More information about the linux-pcmcia mailing list