[RFC v3] PCMCIA locking updates for 2.6.34

[Komuro]

Hi,

>> eth0: 3Com 3c589, io 0x300, irq 3, hw_addr 00:00:86:xx:xx:xx
>>   8K FIFO split 5:3 Rx:Tx, auto xcvr

>Did you modify the hw_addr here, or is it reported wrongly here, compared to

sorry, I modified the hw_addr, so the hw_addr is same between 2.6.33-rc8
and the PCMCIA patches.

> eth8: command 0x5800 did not complete!
> eth8: command 0x5800 did not complete!
> eth8: command 0x5800 did not complete!
> eth8: command 0x5800 did not complete!
> eth8: command 0x5800 did not complete!

Actually, this error happens when the conf->ConfigIndex of the 3com card 
is not set up properly...


Best Regards
Komuro