Help on a texas instruments pci7420 cardbus
linux at dominikbrodowski.net
Wed Sep 28 09:24:19 EDT 2005
On Wed, Sep 28, 2005 at 02:01:13AM +0200, Mårten Thomasson wrote:
> Linux Kernel Card Services
> options: [pci] [cardbus] [pm]
> ACPI: PCI Interrupt 0000:06:00.0[A] -> Link [LNKA] -> GSI 10 (level, low) ->
> IRQ 10
> Yenta: CardBus bridge found at 0000:06:00.0 [1854:000e]
> yenta 0000:06:00.0: Preassigned resource 0 busy, reconfiguring...
> yenta 0000:06:00.0: Preassigned resource 1 busy, reconfiguring...
> Yenta: ISA IRQ mask 0x0078, PCI irq 10
> Socket status: 30000006
Could you test either 2.6.13 or 2.6.14-rc2, please? Alternatively, the
following kernel boot options might or might not help, I'm not familiar with
On Wed, Sep 28, 2005 at 12:31:50AM -0400, Pavel Roskin wrote:
> > When I perform an lspci, its not listed.
> And what is 06:02.0? Does lspci output change if you remove the card?
06:02.0 is on the same bus as the CardBus bridge, therefore I doubt that
this is the CardBus card.
More information about the linux-pcmcia