Testing new HSDPA card
Magnus Öberg
slumpnamn at gmail.com
Tue Nov 8 10:40:25 EST 2005
On 11/8/05, Marcel Holtmann <marcel at holtmann.org> wrote:
>
> it is also a good idea to check the output of lsusb, because some of
> these UMTS cards contain an USB host controller and then a USB to serial
> converter attached to it.
>
> Regards
>
> Marcel
>
There is unfortunately no trace of the card in lsusb either:
lsusb -vv
Bus 001 Device 001: ID 0000:0000
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 1.10
bDeviceClass 9 Hub
bDeviceSubClass 0 Unused
bDeviceProtocol 0
bMaxPacketSize0 8
idVendor 0x0000
idProduct 0x0000
bcdDevice 2.06
iManufacturer 3 Linux 2.6.14emagobe uhci_hcd
iProduct 2 UHCI Host Controller
iSerial 1 0000:00:07.2
bNumConfigurations 1
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 25
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 0
bmAttributes 0xc0
Self Powered
MaxPower 0mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 1
bInterfaceClass 9 Hub
bInterfaceSubClass 0 Unused
bInterfaceProtocol 0
iInterface 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x81 EP 1 IN
bmAttributes 3
Transfer Type Interrupt
Synch Type None
Usage Type Data
wMaxPacketSize 0x0002 bytes 2 twice
bInterval 255
-----
I have tried other cards that use the usb controller and they have
showed up properly in the logs. This one leaves no trace in the logs.
/Magnus Öberg
More information about the linux-pcmcia
mailing list