AW: need help: cs: unable to map card memory

[Jar]

Storm wrote:
> i have toyed around with the installation a bit and found out in the runlevel-editor, that the pcmcia module (including pcmcia_core, yenta_socket and so forth) was scheduled to be started in runlevels 3,4 and 5! surely i do not need to start the same module over and over again in different runlevels? 
You use only one runlevel at the time. I assume you use X-widows, so 
your runlevel would be 5.

> so, despite my boot-option: NOPCMCIA=yes, pcmcia-modules were loaded in the boot process nevertheless. that is why i could find the loaded modules described below by lsmod even though they were actually not supposed to be loaded. so, i have "deleted" the pcmcia-module from the boot process in order to get a "fresh" system pcmcia-wise. currently, i am updating the system with the latest packages from suse. then, a reboot may better show me what i am up against. 
> 
> do you think this is a feasible procedure? 

Ayt least you should check the pcmcia init script (in Fedora Core it is 
/etc/init.d/pcmcia) that is uses pcmcia not ds when it loads/unloads the 
pcmcia system.

-- 
Best Regards, Jar