"unable to apply power" problem in 2.6.6

[Ryan Verner]

Ryan Verner wrote:

> Howdy,
> 
> Found the very recent threads here on the "unable to apply power" 
> problem under 2.6; need to say "me, too".
> 
> I'm trying to configure two Senao 200mW wireless cards, under two Ricoh 
> PCMCIA->PCI bridges, on Debian Stable.  I can't get anything to work, 
> even under 2.4.

I probably should have posted this with the original email, but under 
2.4, the error is "cs: unable to map card memory!".  I've tried all the 
usual changes to /etc/pcmcia/config.opts but to no avail.

All of the above occurs with both 3.3V/5V PCMCIA/Cardbus cards.

I'm stumped as I'm sure I've used these cradles before in different 
systems; perhaps they are slightly different, I don't know.  The system 
they're in is a recent P4 in an Intel board, FYI; and I've booted 
Knoppix suspecting perhaps a configuration blunder on my part but the 
same issues occur.

More detailed lspci of the cradle:

01:04.0 CardBus bridge: Ricoh Co Ltd RL5c475 (rev 80)
         Subsystem: CARRY Computer ENG. CO Ltd: Unknown device 0101
         Flags: bus master, medium devsel, latency 168, IRQ 18
         Memory at 3f001000 (32-bit, non-prefetchable) [size=4K]
         Bus: primary=01, secondary=02, subordinate=05, sec-latency=176
         Memory window 0: 3f400000-3f7ff000 (prefetchable)
         Memory window 1: 3f800000-3fbff000
         I/O window 0: 00004000-000040ff
         I/O window 1: 00004400-000044ff
         16-bit legacy interface ports at 0001

Any suggestions are *very* appreciated.

R