[PATCH 1/5] nvmet: Fix identify Namespace handling

[Damien Le Moal]

The identify command with cns set to NVME_ID_CNS_NS does not directly
depend on the command set. The NVMe specifications is rather confusing
here as it appears that this command only applies to the NVM command
set. However, footnote 8 of Figure 273 in the NVMe 2.0 base
specifications clearly state that this command applies to NVM command
sets that support logical blocks, that is, NVM and ZNS. Both the NVM and
ZNS command set specifications also list this identify as mandatory.

The command handling should thus not look at the csi field since it is
defined as unused for this command. Given that we do not support the
KV command set, simply remove the csi switch-case for that command
handling and call directly nvmet_execute_identify_ns() in
nvmet_execute_identify().

Fixes: ab5d0b38c047 ("nvmet: add Command Set Identifier support")
Signed-off-by: Damien Le Moal <damien.lemoal at opensource.wdc.com>
---
 drivers/nvme/target/admin-cmd.c | 9 ++-------
 1 file changed, 2 insertions(+), 7 deletions(-)

diff --git a/drivers/nvme/target/admin-cmd.c b/drivers/nvme/target/admin-cmd.c
index ceffe2989a91..7fa60b1aee58 100644
--- a/drivers/nvme/target/admin-cmd.c
+++ b/drivers/nvme/target/admin-cmd.c
@@ -675,13 +675,8 @@ static void nvmet_execute_identify(struct nvmet_req *req)
 
 	switch (req->cmd->identify.cns) {
 	case NVME_ID_CNS_NS:
-		switch (req->cmd->identify.csi) {
-		case NVME_CSI_NVM:
-			return nvmet_execute_identify_ns(req);
-		default:
-			break;
-		}
-		break;
+		nvmet_execute_identify_ns(req);
+		return;
 	case NVME_ID_CNS_CS_NS:
 		if (IS_ENABLED(CONFIG_BLK_DEV_ZONED)) {
 			switch (req->cmd->identify.csi) {
-- 
2.39.2