[PATCH 1/4] dt-bindings: mtd: qcom,nandc: Add MDM9607 QPIC NAND controller

[Krzysztof Kozlowski]

On Mon, Jun 08, 2026 at 03:20:22PM +0200, Stephan Gerhold wrote:
> Add the qcom,mdm9607-nand compatible for the QPIC NAND controller used
> inside the MDM9607 SoC.
> 
> On MDM9607, there is only a single controllable clock for the NAND
> controller (RPM_SMD_QPIC_CLK). The same situation also applies e.g. for
> qcom,sdx55-nand, but the corresponding device tree (qcom-sdx55.dtsi) works
> around that by assigning a dummy clock (&nand_clk_dummy) to the second
> clock ("aon") that is required by the dt-bindings. This is not really
> useful, so avoid doing that for new platforms by excluding the second "aon"
> clock entry in the dt-bindings.
> 
> Signed-off-by: Stephan Gerhold <stephan.gerhold at linaro.org>
> ---
>  .../devicetree/bindings/mtd/qcom,nandc.yaml        | 24 ++++++++++++++++++++++
>  1 file changed, 24 insertions(+)

Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski at oss.qualcomm.com>

Best regards,
Krzysztof