[PATCH v3 02/13] spi: dt-bindings: cdns,qspi-nor: add PHY tuning pattern partition property

[Santhosh Kumar K]

On 02/06/26 18:18, Krzysztof Kozlowski wrote:
> On 02/06/2026 14:36, Miquel Raynal wrote:
>> Hello,
>>
>>>>>>> I also have doubts that this is per-device property. Your commit msg
>>>>>>> suggests it is per controller.
>>>>>>
>>>>>> This is a per-device property. It is consumed by the controller driver
>>>>>> only to locate and retrieve the offset of the PHY pattern partition
>>>>>
>>>>> So with two devices on a bus, you need two separate partitions for tuning?
>>>
>>> Each SPI NOR flash device needs a partition to store PHY tuning
>>> pattern.
>>
>> If I may try to explain a bit what is behind, the read tuning procedure
>> is about reading data from the spi memory cache (some kind of internal
>> SRAM) over and over again, while tuning the controller parameters until
>> we get the best stability (the controller driver knows the pattern it
>> must get). While SPI NAND chips have "write to cache" opcodes that could
>> be used to load the pattern into the chip without any actual read from
>> the memory array, this is not possible with SPI NOR devices which do not
>> have such capability. Since we want to keep this training procedure
>> memory agnostic (and also somewhat simple), we shall expect one pattern
>> per memory.
> 
> Can pieces of above be captured in commit msg, so it will be clearer to
> folks without domain knowledge?

Sure, I'll add a brief overview of the tuning procedure in the commit
message in v4.

Thanks,
Santhosh.

> 
> Best regards,
> Krzysztof