[PATCH v3 02/13] spi: dt-bindings: cdns,qspi-nor: add PHY tuning pattern partition property

[Miquel Raynal]

Hello,

>>>>> I also have doubts that this is per-device property. Your commit msg
>>>>> suggests it is per controller.
>>>>
>>>> This is a per-device property. It is consumed by the controller driver
>>>> only to locate and retrieve the offset of the PHY pattern partition
>>>
>>> So with two devices on a bus, you need two separate partitions for tuning?
>
> Each SPI NOR flash device needs a partition to store PHY tuning
> pattern.

If I may try to explain a bit what is behind, the read tuning procedure
is about reading data from the spi memory cache (some kind of internal
SRAM) over and over again, while tuning the controller parameters until
we get the best stability (the controller driver knows the pattern it
must get). While SPI NAND chips have "write to cache" opcodes that could
be used to load the pattern into the chip without any actual read from
the memory array, this is not possible with SPI NOR devices which do not
have such capability. Since we want to keep this training procedure
memory agnostic (and also somewhat simple), we shall expect one pattern
per memory.

Thanks,
Miquèl